Bedienungsanleitung Gardenline BC35TS-2 (Seite 19 von 26) (Englisch)

724647

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

31cc Brushcutter / Line Trimmer

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. BC35TS-2 • 08/2018 • 49290

(toll free)

AFTER SALES SUPPORT

(toll free)

31cc Brushcutter / Line Trimmer

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. BC35TS-2 • 08/2018 • 49290

34 35

• Never smoke or light any res near the product or fuels.

• Always transport and store fuels in an approved container.

• Never place ammable material close to the engine muer.

• Never operate the product without a properly functioning muer and

spark plug cover installed.

• Never operate the product unless it is properly assembled and in good

working condition.

• Do not use fuel which contains ethanol or methanol as it may damage

the fuel lines and other engine parts.

Use fresh unleaded fuel.

Starting the Brushcutter / Line Trimmer

Choke control

Start position (choke closed)

Run position (choke open)

1. Slide the on/o switch (10) to the ‘ON’ position

(towards the engine) as marked with a “I” below

the switch on the side of the handle housing

(Fig BA).

2. Move the choke (red lever) (22) (which is

located behind the air lter cover (3) housing,

and just above the fuel tank cap (5) upwards to

the full choke or cold start position (Fig. BB).

NOTE. This is not required if the engine is

already warm.

3. Push the priming bulb (23)(which is located

above the choke lever) 6-10 times, until the

priming bulb lls with fuel mixture and excess

fuel is pumped down the bypass tube when the

bulb is pressed (Fig BC).

NOTE. For cold starting this is an important

step.

BB.

BC.

BA.

4. Engage the start trigger lock button (7) to assist

in the motor starting. To engage the start trigger

lock button (7), depress the safety lever (9) and

then the throttle trigger (8) fully.

While these two parts are depressed, push

downward and forward and hold on the throttle

start lock button (7) (Fig BD).

Slowly release the throttle trigger (8) and the

safety lever (9) until released. The throttle start

trigger lock button (7) will be locked down and

can also be released.

5. Check the ignition on/o switch (10) is ‘ON’.

Pull the recoil starter (2) lightly until you feel

resistance then pull quickly until the engine

starts (Fig. BE) (Under full choke it may only

run for 1 or 2 seconds).

6. Push the choke (red lever) (22) half way down

and allow the motor to warm up. Restart if the

motor stops.

Do not pull the cord with a jerk or release it until

fully rewound. Provided the previous steps have

been performed, the motor should start.

As soon as the motor starts and is running,

depress the safety lever (9) and pull the throttle

trigger (8) on and then immediately release the

throttle trigger (8). This will disengage the start trigger lock button (7) and

the motor will reduce to Idle speed.

BE.

BD.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline BC35TS-2 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info