Bedienungsanleitung Gardenline EBV245A (Seite 11 von 19) (Englisch)

724645

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

24.5cc 4 Stroke Petrol Blower Vacuum

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. EBV245A • 08/2018 • 52754

(toll free)

AFTER SALES SUPPORT

(toll free)

24.5cc 4 Stroke Petrol Blower Vacuum

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. EBV245A • 08/2018 • 52754

18 19

4. Clean the dipstick portion of any oil residue and

then insert the dipstick fully into the oil reservoir,

however, DO NOT THREAD the dipstick into the

reservoir. Hold the dipstick in place for a few

seconds and then remove (Fig O).

5. Check the oil mark on the dipstick. It should reach

the middle hole on the dipstick. Be careful not to

overll (Fig P).

6. If the oil level is not close to the middle hole,

then add small amounts of oil and repeat steps 3, 4 & 5 until the oil level is

approaching the middle hole on the dipstick.

DO NOT OVERFILL. Do Not EXCEED the upper hole on the dipstick.

7. IMPORTANT: The motor should NEVER be started if the oil level is below

the lowest hole.

Always check the oil level before starting ensuring the blower vacuum is

positioned as per step1 for checking.

8. When the oil level reaches the middle hole, replace the dipstick (14) and

thread in the dipstick in a clockwise direction until the dipstick is rmly in

place. The Sealing O ring on the shoulder of the dipstick should be fully

compressed when the dipstick is rmly hand tightened.

Adding and Checking the oil

IMPORTANT: The motor of this blower vacuum is packed with NO OIL in

the motor. Prior to starting the motor, 4 stroke oil MUST be added to the oil

reservoir (14). Failure to add sucient oil will result in damage to the motor

which is NOT covered under the warranty of the unit.

NOTE: This is a 4 stroke blower vacuum. The motor sump MUST be lled with

60mL of 4 stroke SAE 10W/30 BEFORE starting. Fresh unleaded fuel must be

used in this unit. Do not use ethanol based fuels.

Do NOT mix oil with fuel. Oil must be separately poured into the sump of

the motor as follows, and also the oil level MUST be checked every time the

blower is used.

NEVER attempt to remove the oil dipstick (14) while the motor is running.

ENSURE the motor is not running when the oil level is being checked.

On a new unit, the motor needs to be lled with 60mL of SAE 10W/30

engine oil.

To initially ll with oil or to check the oil level, follow the process below.

1. Sit the blower on its side such that the intake cover is resting on a secure

at surface, or on the ground, and the oil reservoir is easily accessible

(Fig M). Clean the area directly around the oil reservoir (14) (Fig N).

2. Fully remove/unthread the oil dipstick in an anti clockwise direction.

3. On a new unit which has not previously been lled with oil, measure 60mL

of SAE 10W/30 oil

and pour into the oil

reservoir (14), using

a funnel, where the

dipstick was removed.

N.M.

CORRECT

LEVEL

(MIDDLE HOLE)

DO NOT

OVERFILL

(TOP HOLE)

Preparation Preparation

Preparation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline EBV245A Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info