Bedienungsanleitung Gardenline XKJ1109 (Seite 12 von 21) (Englisch)

724631

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

1100W Garden Pump

AFTER SALES SUPPORT

e-mail: info.aldi@positecgroup.com

1300 889 028

MODEL: №. XKJ-1109PE • 1/2019 • 44268

(toll free)

AFTER SALES SUPPORT

(toll free)

1100W Garden Pump

e-mail: info.aldi@positecgroup.com1300 889 028

MODEL: №. XKJ-1109PE • 1/2019 • 44268

20 21

Connecting to the intake port (6) (Where water is to be

transferred from)

The Intake connection is to be connected to your

water supply via various connections (not supplied).

An example set up is shown here (Fig Q).

The intake port (6) of the pump is 1” BSP.  So to

purchases of any ttings for the intake port (6) of

the pump, the threaded tting is required to be

1” BSP. This is shown as number 6 on page 8.

For the intake port (6), purchased ttings can be

used directly into the intake port (6) of the pump.

The tting supplied which is not being used on the pressure outlet (5) can

be used on the intake port (6) if required, however it is critical one of the

supplied ttings is used into the pressure outlet (5) of the pump.

Extra ttings can also be purchased from our online spare parts store.

Description NOTE: Teon tape (not supplied) is applied to all ttings

requiring tape for correct assembly.

Connecting the intake hose / suction pipe.

1. Screw an intake hose* minimum of 19mm (3/4”) diameter hose preferably

spiral re-inforced. This may be directly, or with a threaded nipple to the

pump’s intake port (6) (25 mm (R1) (1” BSP)).

2. The intake hose* should rise from the water pick-up point up to the

pump. Always avoid laying the intake line higher than the pump as

this will cause air bubbles in the intake line which will delay and hinder

suction (Refer previous Fig C).

3. The intake and pressure lines* must be attached in such a way that they

do not place the pump under any mechanical strain.

4. If the intake line* is not air-tight the intake of air will hinder the intake

of water.

Purchased components for plumbed inlet: 

Figures R & S show the components for the plumbed threaded inlet

for a non pressure connection.

The tting supplied which is not being used on the pressure outlet (5) can be

used on the intake port

(6) if required, HOWEVER,

it is critical one of the

supplied adaptor ttings

(10 & 11) is used into the

pressure outlet of the

pump (5).

Preparing your pump for operation for the rst use.

NOTE: Ensure the unit is NOT connected to the mains power when

undertaking this task (Fig A).

NOTE: During the priming process if your pump is connected to a tap, ensure

the tap is open (Fig T).

Once the preparation of the pump is complete, you are ready to prime the

pump.

Preparing to prime your Garden Pump

The objective/process of priming your pump is to remove air from the system.

1. Set up the pump on at and rm ground (refer Fig C).

2. Using the spanner (8), unscrew the clear water ller cap (1) (Fig U) and

remove the coarse lter (2) together with the non-return valve (3) (Fig V/W).

NOTE: If the lter and

non-return valve does

not lift out of the pump,

remove the water intake

screw (7) (Fig X) and

gently push the non

return valve (3) upward

using the end of the

supplied spanner (8)

(Fig Y).

R. S.

T. U.

LOOSEN

OPEN

TIGHTEN

* Additional ttings are NOT supplied with this garden pump.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline XKJ1109 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info