Bedienungsanleitung Garmin BabyCam (Seite 6 von 10) (Englisch)

629013

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

You should place the clamp and insert as close to the

headrest as possible without blocking the camera view by

any portion of the headrest.

Close the bolt

, and turn the knob

clockwise until the

clamp is tight.

TIP:

For larger headrest posts, you may need to loosen the

knob to close the bolt.

The clamp should not slide on the post when tightened. If the

clamp does slide, you should use a thicker rubber insert.

Lower the headrest until the camera is at the desired height.

NOTICE

The headrest must lock into the seat after the camera is

installed. If the headrest does not lock, the camera should not

be installed on this headrest.

Adjusting the Camera Position Using the Standard

Headrest Mount

You can adjust the camera angle and orientation to include the

optimal area in the video frame. While adjusting the camera, it

can be helpful to view the video feed on your navigation device

for reference (Viewing babyCam Video, page 4).

• To point the camera left or right, loosen the clamp by turning

the knob

counterclockwise, and rotate the clamp on the

headrest post.

• To level the camera orientation, loosen the threaded ring

by turning it one full turn counterclockwise, and turn the

camera until the subject is level in the video frame.

• To point the camera up or down, loosen the thumbscrew

by turning it counterclockwise, and tilt the camera up or

down.

After you are finished adjusting the camera position, you should

verify the knob, threaded ring, and thumbscrew are fully

tightened.

Extension Arm Accessory

The optional extension arm accessory allows you to install the

camera on an adjustable headrest that overhangs the top of the

seat. The arm extends around the overhanging portion of the

headrest and holds the camera in front of the headrest. Go to

garmin.com

/babycam

to purchase mounting accessories.

Assembling the Mount and Extension Arm for an

Overhanging Headrest

You should assemble the mount and extension arm before you

mount the camera on the headrest.

Place the mounting connector

on the clamp

You should align the mounting connector as shown in the

illustration.

Place the threaded ring

over the mounting base, and turn it

clockwise to tighten.

Insert the extension arm

into the mounting base and

secure it using the thumbscrew

Mounting the Camera on an Overhanging Headrest

Before you mount the camera on an overhanging headrest, you

should assemble the mount and extension arm.

Raise the headrest from the vehicle seat to expose the

headrest posts.

Place one rubber insert

around the headrest post.

NOTE:

Two sizes of rubber inserts are included. You should

use the rubber insert that fits easily and tightly onto the post.

Place the clamp

around the rubber insert.

You should place the clamp and insert close to the headrest.

Close the bolt

, and turn the knob

clockwise until the

clamp is tight.

The clamp should not slide on the post when tightened. If the

clamp does slide, you should use a thicker rubber insert.

TIP:

You can adjust the depth of the extension arm by

rotating the clamp on the post.

Place the camera onto the extension arm

, and secure it

using a thumbscrew

2 Installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin BabyCam Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin BabyCam

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info