Bedienungsanleitung Garmin Descent G1 (Seite 78 von 134) (Englisch)

801440

Zoom out

Zoom in

Vorherige Seite

1/134

Nächste Seite

Pulse Oximeter

The Descent watch has a wrist-based pulse oximeter to gauge the saturation of oxygen in your blood. Knowing

your oxygen saturation can be valuable in understanding your overall health and help you determine how your

body is adapting to altitude. Your watch gauges your blood oxygen level by shining light into the skin and

checking how much light is absorbed. This is referred to as SpO2.

On the watch, your pulse oximeter readings appear as an SpO2 percentage. On your Garmin Connect account,

you can view additional details about your pulse oximeter readings, including trends over multiple days (Setting

the Pulse Oximeter Mode, page70). For more information on pulse oximeter accuracy, go to garmin.com

/ataccuracy.

Getting Pulse Oximeter Readings

You can manually begin a pulse oximeter reading by viewing the pulse oximeter glance. The glance displays

your most recent blood oxygen saturation percentage.

1While you are sitting or inactive, press UP or DOWN to view the pulse oximeter glance.

2Wait until the watch begins the pulse oximeter reading.

3Remain motionless for up to 30 seconds.

NOTE: If you are too active for the watch to get a pulse oximeter reading, a message appears instead of a

percentage. You can check again after several minutes of inactivity. For best results, hold the arm wearing

the watch at heart level while the watch reads your blood oxygen saturation.

Setting the Pulse Oximeter Mode

1Hold MENU.

2Select Sensors & Accessories > Pulse Oximeter > Pulse Ox Mode.

3Select an option:

• To turn off automatic measurements, select Manual Check.

• To turn on continuous measurements while you sleep, select During Sleep.

NOTE: Unusual sleep positions can cause abnormally low sleep-time SpO2 readings.

• To turn on measurements while you are inactive during the day, select All Day.

NOTE: Turning on All Day mode decreases battery life.

Tips for Erratic Pulse Oximeter Data

If the pulse oximeter data is erratic or does not appear, you can try these tips.

• Remain motionless while the watch reads your blood oxygen saturation.

• Wear the watch above your wrist bone. The watch should be snug but comfortable.

• Hold the arm wearing the watch at heart level while the watch reads your blood oxygen saturation.

• Use a silicone or nylon band.

• Clean and dry your arm before putting on the watch.

• Avoid wearing sunscreen, lotion, and insect repellent under the watch.

• Avoid scratching the optical sensor on the back of the watch.

• Rinse the watch with fresh water after each workout.

Compass

The watch has a 3-axis compass with automatic calibration. The compass features and appearance change

depending on your activity, whether GPS is enabled, and whether you are navigating to a destination. You can

change the compass settings manually (Compass Settings, page71).

70 Sensors and Accessories

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Descent G1 Seite 78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Descent G1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info