Bedienungsanleitung Garmin Descent G1 (Seite 79 von 134) (Englisch)

801440

Zoom out

Zoom in

Vorherige Seite

1/134

Nächste Seite

Compass Settings

Hold MENU, and select Sensors & Accessories > Compass.

Calibrate: Allows you to manually calibrate the compass sensor (Calibrating the Compass Manually, page71).

Display: Sets the directional heading on the compass to letters, degrees, or milliradians.

North Ref.: Sets the north reference of the compass (Setting the North Reference, page71).

Mode: Sets the compass to use electronic-sensor data only (On), a combination of GPS and electronic-sensor

data when moving (Auto), or GPS data only (Off).

Calibrating the Compass Manually

NOTICE

Calibrate the electronic compass outdoors. To improve heading accuracy, do not stand near objects that

influence magnetic fields, such as vehicles, buildings, and overhead power lines.

Your watch was already calibrated at the factory, and the watch uses automatic calibration by default. If you

experience irregular compass behavior, for example, after moving long distances or after extreme temperature

changes, you can manually calibrate the compass.

1Hold MENU.

2Select Sensors & Accessories > Compass > Calibrate > Start.

3Follow the on-screen instructions.

TIP: Move your wrist in a small figure eight motion until a message appears.

Setting the North Reference

You can set the directional reference used in calculating heading information.

1Hold MENU.

2Select Sensors & Accessories > Compass > North Ref..

3Select an option:

• To set geographic north as the heading reference, select True.

• To set the magnetic declination for your location automatically, select Magnetic.

• To set grid north (000º) as the heading reference, select Grid.

• To set the magnetic variation value manually, select User > Mag. Variation, enter the magnetic variation,

and select Done.

Altimeter and Barometer

The watch contains an internal altimeter and barometer. The watch collects elevation and pressure data

continuously, even in low-power mode. The altimeter displays your approximate elevation based on pressure

changes. The barometer displays environmental pressure data based on the fixed elevation where the altimeter

was most recently calibrated (Altimeter Settings, page71).

Altimeter Settings

Hold MENU, and select Sensors & Accessories > Altimeter.

Calibrate: Allows you to manually calibrate the altimeter sensor.

Auto Cal.: Allows the altimeter to self-calibrate each time you use satellite systems.

Sensor Mode: Sets the mode for the sensor. The Auto option uses both the altimeter and barometer according

to your movement. You can use the Altimeter Only option when your activity involves changes in altitude, or

the Barometer Only option when your activity does not involve changes in altitude.

Elevation: Sets the units of measure for elevation.

Sensors and Accessories 71

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Descent G1 Seite 79

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Descent G1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info