Bedienungsanleitung Garmin GPSMAP 8417 MFD (Seite 37 von 62) (Englisch)

658523

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

From the radar screen, select Menu > Radar Setup >

Installation > Antenna Configuration > Park Position.

Use the slider bar to adjust the position of the antenna when

stopped, and select Back

Selecting a Different Radar Source

Select an option:

• From a radar screen or the radar overlay, select Menu >

Radar Setup

> Source

• Select Settings > Communications

> Preferred

Sources > Radar

Select the radar source.

Autopilot

WARNING

You can use the autopilot feature only at a station installed next

to a helm, throttle, and helm control device.

You are responsible for the safe and prudent operation of your

vessel. The autopilot is a tool that enhances your capability to

operate your boat. It does not relieve you of the responsibility of

safely operating your boat. Avoid navigational hazards and

never leave the helm unattended.

Always be prepared to promptly regain manual control of your

boat.

Learn to operate the autopilot on calm and hazard-free open

water.

Use caution when operating the autopilot near hazards in the

water, such as docks, pilings, and other boats.

The autopilot system continuously adjusts the steering of your

boat to maintain a constant heading (heading hold). The system

also allows manual steering and several modes of automatic-

steering functions and patterns.

Opening the Autopilot Screen

Before you can open the autopilot screen, you must have a

compatible autopilot installed and configured.

Select A/V, Gauges, Controls > Autopilot.

Autopilot Screen

Actual heading

Intended heading (heading the autopilot is steering toward)

Actual heading (when in standby mode)

Intended heading (when engaged)

Rudder position indicator (This functionality is available only when a

rudder sensor is connected.)

Adjusting the Step Steering Increment

From the Autopilot screen, select Menu > Autopilot Setup >

Step Turn Size.

Select an increment.

Setting the Power Saver

You can adjust the level of rudder activity.

From the autopilot screen, select Menu > Autopilot Setup >

Power Mode Setup

> Power Saver

Select a percentage.

Selecting a higher percentage reduces rudder activity and

heading performance. The higher the percentage, the more

the course deviates before the autopilot corrects it.

TIP: In choppy conditions at low speeds, increasing the

Power Saver

percentage reduces rudder activity.

Enabling Shadow Drive

™

NOTE: The

Shadow Drive feature is available only on hydraulic

steering systems.

From the autopilot screen, select

Menu > Autopilot Setup >

Shadow Drive

> Enabled

Engaging the Autopilot

When you engage the autopilot, the autopilot takes control of the

helm and steers the boat to maintain your heading.

From any screen, select

Engage.

Your intended heading shows in the center of the Autopilot

screen.

Adjusting the Heading with the Helm

NOTE:

You must enable the Shadow Drive feature before you

can adjust the heading using the helm (

Enabling Shadow

Drive

™

, page 29).

With the autopilot engaged, manually steer the boat.

The autopilot activates

Shadow Drive mode.

When you release the helm and manually maintain a specific

heading for a few seconds, the autopilot resumes a heading

hold at the new heading.

Adjusting the Heading with the Chartplotter in Step

Steering Mode

Before you can steer your boat using the keys at the bottom of

the autopilot screen, you must engage the autopilot (Engaging

the Autopilot, page 29).

• Select

<1° or 1°> to initiate a single 1° turn.

• Select

<<10° or 10°>> to initiate a single 10° turn.

• Hold

<1° or 1°> to initiate a rate-controlled turn.

The boat continues to turn until you let go of the key.

• Hold

<<10° or 10°>> to initiate a sequence of 10° turns.

Steering Patterns

WARNING

You are responsible for the safe operation of your boat. Do not

begin a pattern until you are certain that the water is clear of

obstacles.

The autopilot can steer the boat in preset patterns for fishing,

and it can also perform other specialty maneuvers such as U-

turns and Williamson turns.

Following the U-Turn Pattern

You can use the u-turn pattern to turn the boat around 180

degrees and maintain the new heading.

From the autopilot screen, select Menu > Pattern Steering >

U-Turn.

Select

Engage Port or Engage Starboard.

Setting Up and Following the Circles Pattern

You can use the circles pattern to steer the boat in a continuous

circle, in a specified direction, and at a specified time interval.

Autopilot 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GPSMAP 8417 MFD Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GPSMAP 8417 MFD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info