813468
4
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
4
2.3 Dispose of old batteries at an appropriate recycling facility.
When using the handset:
2.4 Ensure the handset is pointed at the infrared sensor
located behind the flame effect screen at the back of the
inside of the appliance.
LOCATION OF POWER SWITCH
2.5 The mains power switch is located on the control panel on
the lower right-hand side of the stove, see Diagram 1.
2.6 Switch ON () before operating either the remote or
manual controls.
2.7 A beep is heard to indicate the fire is ready for use.
Remote & Manual Operation
2.8 The following functions can be controlled using the manual
controls or remote handset:
— Heat settings 1 and 2
— Brightness of the fuel and flame effect
— Colour of the flames
2.9 The Standby function and the thermostat can only be
operated via the manual controls.
2.10 The effects can be turned off using the remote, returning the
appliance to Standby.
Flame effect button Standby
On/Off Switch
Thermostat
Heat setting button
1
On/Off button
Flame effect
Heat setting 1kW
Heat setting 2kW
2
Standby On/Off
2.11 The appliance is in Standby mode when the power is
switched on via the manual control panel. You must have
this power supply ON () before using the manual or
remote controls (see 2.5).
Turning On the Appliance
Flame Effects:
2.12 The flame effect button on both the manual and remote
controls has 4 settings:
— Press once for maximum brightness of fuel and
flame effects.
— Press twice for medium brightness.
— Press three times for minimum brightness.
— Press four times for maximum brightness of fuel and
additional blue flame effects.
1234
Maximum Medium Minimum
Maximum
plus blue
ame effects
Turning On the Heat:
2.13 When turning on the heater you must always press the
1kW button. Do not start the fire using the 2kW setting.
2.14 It is NOT advisable to run the heater without the flame
effects switched on.
2.15 Press the 1kW button to turn the fan heater ON. One
red indicator light will be displayed behind the flame effect
screen at the back of the inside of the appliance. The
appliance will blow cold air for approximately 8 seconds
before the heater comes on. On this setting the heater will
operate at half its maximum temperature.
2.16 Press the 2kW button once to turn the fan heater to its
maximum temperature. Two red indicator lights will be
displayed behind the flame effect screen at the back of the
inside of the appliance. After approximately 8 seconds the
heater will operate at its maximum temperature.
2.17 Pressing the 2kW button again will turn the heater OFF
and cold air will be blown for approximately 8 seconds to
cool the appliance.
2.18 Press the 1kW button to return to the lower heat setting.
2.19 Press the On/Off button to turn off ALL settings and
return to Standby. Cold air will be blown for
approximately 8 seconds to cool the appliance.
2.20 The appliance should be turned off via the On/Off
switch when it is not in use.
User Instructions
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gazco Ashdon - Electric wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gazco Ashdon - Electric

Gazco Ashdon - Electric Bedienungsanleitung - Holländisch - 20 seiten

Gazco Ashdon - Electric Bedienungsanleitung - Französisch - 20 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info