7.2 Place log B on the left hand side of the burner with the
location bar on the underside of the log fully located in the
long slot of the burner. Make sure the log is as far to the left
as possible. See diagram 3.
7.3 Place log C on the right hand side of the burner with the
location bar on the underside of the log fully located in the
long slot in the burner. Make sure the log is as far right as
possible. See diagram 4.
5
5. HANDLING & DISPOSAL OF FIRE CERAMICS
5.1 The fuel effect and side panels in this appliance are made
from Refractory Ceramic Fibre (RCF), a material which is
commonly used for this application.
5.2 Protective clothing is not required when handling these
articles, but we recommend you follow normal hygiene rules
of not smoking, eating or drinking in the work area and
always wash your hands before eating or drinking.
5.3 To ensure that the release of RCF fibres are kept to a
minimum, during installation and servicing a HEPA filtered
vacuum is recommended to remove any dust accumulated
in and around the appliance before and after working on it.
When servicing the appliance it is recommended that the
replaced items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF waste.
5.4 RCF waste is classed as stable, non-reactive hazardous waste
and may be disposed of at a licensed landfill site.
5.5 Excessive exposure to these materials may cause temporary
irritation to eyes, skin and respiratory tract; wash hands
thoroughly after handling the material.
6. CLEANING THE FIRE
6.1 Only clean the stove when it is cold.
6.2 Remove the four black nuts retaining the door. Take care
when removing the door as it is heavy.
6.3 Remove all of the ceramic logs, being especialy careful
handling the front ash panels.
6.4 The logs should not require cleaning. Do not use a vacuum
cleaner or brush to clean the logs, any large pieces of debris
may be removed by hand.
6.5 Ensure any debris is removed from the burner ports.
6.6 Replace the ceramics and door referring to section 7.
6.7 Use a damp cloth to clean the outer casing of the appliance.
7. FUEL BED ARRANGEMENTS
Remove the cast iron door using the tool provided. Remove
the front coal retainer by lifting vertically.
NOTE: THE CAST IRON DOOR IS HEAVY, TAKE EXTREME
CARE WHEN HANDLING TO AVOID DAMAGING THE
OUTER CASING.
The fuel bed consists of 5 logs and 2 ash panels. The logs
have letters A,B,C,D and E moulded into them for
identification.
7.1 Take the rear log A and place it up against the rear of the
fire sitting on the two flat ledges of the burner. The two legs
of the log should sit between the rear burner ports. See
diagram 2. Ensure there is an equal gap between each side
of the log and the side of the firebox.
USER INSTRUCTIONS
2
AR1610
3
AR1611
4
AR1612
