Bedienungsanleitung Gazco F40 Avanti Conventional Coal (Seite 10 von 23) (Englisch)

813396

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

ENSURE THAT THE APPLIANCE IS CORRECTLY

ADJUSTED FOR THE GAS TYPE AND CATEGORY

APPLICABLE IN THE COUNTRY OF USE. REFER TO THE

DATABADGE AND TECHNICAL SPECIFICATIONS ON

PAGE 9

FOR DETAILS OF CHANGING BETWEEN GAS TYPES

REFER TO SECTION 11 OF THE SERVICING

INSTRUCTIONS.

1. CONTROL UPGRADE

1.1 This stove is fitted with a control valve that can be easily

upgraded to battery powered remote control. There are two

versions of this control which can be obtained through your

local Gazco stockist.

1.2 This upgrade can be fitted before or after installation but if

side clearances are limited then it will be easier to upgrade

the stove before installation. Full instructions are included

with the kit.

1.3 STANDARD REMOTE CONTROL

This remote control can control the gas appliance after the

pilot has been lit. It can turn the main burner on and

regulate it from low through to high and back again. It can

turn the main burner off leaving the pilot burning. GAZCO

PART NUMBER 8455.

1.4 THERMOSTATIC AND TIMER REMOTE CONTROL

This remote control can control the gas appliance after the

pilot has been lit. In "MANUAL MODE" it can be used to

turn the main burner on and manually regulate it from low

through to high and back again. It can also be used to turn

the main burner off leaving the pilot burning. In "AUTO

MODE" it will automatically regulate the room temperature.

In "TIMER MODE" it will turn the fire on and off according to

a pre-set programme and automatically regulate the room

temperature during two on periods. GAZCO PART NUMBER

8456.

2. SAFETY PRECAUTIONS

2.1 This appliance must be installed in accordance with the rules

in force, and used only in a sufficiently ventilated space.

Place read these instructions before installation and use of

this appliance.

2.2 All the instructions must be left intact with the user.

2.3 In your own interests and those of safety, this appliance must

be installed by a competent person in accordance

with local and national codes of practice. Failure to install

the appliance correctly could lead to prosecution.

2.4 This appliance is intended for use on a governed gas

installation and set to the required pressure.

2.5 Keep all plastic bags away from young children.

2.6 Do not place any object on or near to the stove. Allow

adequate clearance above the stove. See diagram 2 Site

Requirements, Appliance Location.

2.7 The stove is fitted with the Gazco Flue Sure System, which

will act to cut off the gas supply to the appliance in the

event of incorrect operation of the flue. If the system acts to

shut off the gas supply, this indicates that there is insufficient

flue pull. If this occurs a minimum of 10 minutes should be

allowed before trying to relight. Continued operation of this

safety device means that there may be a serious problem

with the flue system; a qualified gas engineer should inspect

this. DO NOT USE THE STOVE UNTIL AN ENGINEER SAYS

IT IS SAFE TO DO SO.

2.8 The Flue Sure System must not be tampered with. Use only

genuine Gazco replacement parts when servicing the system

- refer to Servicing section, Replacing Parts.

3. INSTALLATION OF THE STOVE

3.1 Remove the appliance from its packaging. It will now be

necessary to decide upon top or rear flue exit, the stove is

factory built for rear exit but is easily converted by swapping

the flue spigot with the blanking plate and putting the

blanking plate on the rear of the stove.

3.2 Open the lower door by pressing until a “click” is heard,

and gently lowering down.

3.3 Remove the glass frame by undoing the six pozidrive

screws. The four black screws are for removing the entire

firebox if required. Remove the ceramic components and

place carefully to one side. Remove the lower cover panel

by undoing the two pozidrive screws. See diagram 1.

AR1454

3.4 Undo the two screws at the back of the firebox and gently

pull the burner unit forward. See diagram 2.

AR1457

3.5 At the rear of the burner unit, undo the thermocouple and

disconnect the TTB leads. Now remove the burner unit

completely. See diagram 3.

INSTALLATION INSTRUCTIONS

INSTALLATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gazco F40 Avanti Conventional Coal Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info