51
Cycle computer
Symptom Cause / Possibility Remedy
The cycle computer is not
displayed when you push
the battery power button.
The amount of battery charge may be
insufficient.
Recharge the battery, and then turn the
power on once more.
Is the power turned on?
Hold down the power button to turn on
the power.
Is the battery charging?
The power cannot be turned on while the
battery is mounted on the bicycle and
being charged. Stop charging.
Is the cycle computer correctly installed to
the bracket?
Install the cycle computer correctly while
referring to "Installing and removing the
cycle computer".
Is the electric wire connector correctly
installed?
Check to see if the connector of the electric
wire connecting the motor unit to drive
unit is not disconnected. If you are not
sure, contact the place of purchase.
A component that the system cannot
identify may be connected.
Contact the place of purchase.
<SC-E6010>
The system does not start
up when you press and hold
the cycle computer power
button for 2 seconds.
Did you use the cycle computer in, or
expose it to, low temperatures for an
extended period?
The cycle computer may become unable to turn
on if used in, or exposed to, low temperatures
for an extended period. Turn it on by pressing
the power button on the battery. If it still does
not turn on, consult a dealer.
Is the cycle computer correctly installed to
the bracket?
Install the cycle computer correctly while
referring to "Installing and removing the
cycle computer".
The gear position is not
displayed.
The gear position is only displayed when
the electronic gear shifting unit is installed.
Check if the electric wire connector is
disconnected. If you are not sure, contact
the place of purchase.
Can the beep be turned off.
Change the setting.
Refer to "Beep".
Can the backlight be turned
off.
Change the setting.
Refer to "Backlight".
The setting menu cannot be
launched while riding the
bicycle.
The product is designed so that if it detects
that the bicycle is being ridden, the Setting
menu cannot be launched. This is not a sign
of an abnormality.
Stop the bicycle and then make the
settings.
