Bedienungsanleitung Gemini 7590T2-1 (Seite 4 von 6) (Englisch)

479863

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

PAGE 6

PAGE 7

PROGRAMMING THE ALARM SYSTEM

Has been previously programmed with standard configuration during

manufacturing procedure by Gemini, and can be modified in any moment

With alarm being disarmed, open and keep it open the driver side door.

Turn the ignition "ON".

he status led stay on for 0,5 seconds; during this time, push both the two

buttons of the remote control at the same time.

Starting of programming procedure is indicated by two flashes of the

vehicle indicators.

To activate and de-activate the functions, follow the below table, taking

into consideration that every time the transmitter button is pressed, the

system moves to the next function.

During the programming phases, press the radio control (rough) push-button

n.1, for function activation and the (smooth) push-button n.2, for function de-

activation.

For the programming modification proceed as follows:

Coninuous or intermittent

siren sound

Double pulse when opening

Panic or boot opening

function

Setting of centralized lock

times (0,5 - 6 sec)

25 seconds comfort closure

command

Power drain must remain

disabled

Anti-distraction, automatic

door locking function

Continuous

Disabled

0,5” selected

Disabled

Panic function

enabled

Button N°1- Intermittent

N°2-

N°1-

N°2- Enable

N°1-

N°2-

---------

N°2-

Button Continuous

Button Enable 6”

Button 0,5”

Button Enable

Button Disable

Button N°1- Enable

Button N°2- Disable

Button Disable

Button N°1- Enable panic

Button N°2- Enable car-finder

Button N°1- Enable

Button N°2- Disable

FUNCTION STATE BUTTON

NOTE: “

Once the last function has been programmed, the alarm will flash the

vehicles indicators and the LED twice confirming the exit of the

programming procedure.

Turn the ignition “OFF”.

by turning the ignition key to OFF”, the alarm will exit the programming

procedure with all the changes stored.

LEARNING OF NEW CONTROL DEVICES

ATTENTION: in order to carry out successfully the operation, it is

necessary to make the required electrical connections (door switch,

bonnet switch and positive under key).

ATTENTION:

The alarm can save to memory a maximum number of 12 control devices,

either radio controlled, or electronic keys, TAG cards or magnetic contact (the

later as a protection device).

Proceed as follows:

With the alarm being disarmed, open and keep open the bonnet and the

driver side door.

Turn the ignition “ON”.

The alarm will indicate the procedure starting by two slow flashes of the

turn signal; now the alarm is waiting for receiving the device code.

Press the radio control push-button 1, introduce the electronic key in the

specific receptacle, press the TAG card button, make the magnetic contact

to transmit (bring near and then take away contact and magnet) or make the

infrared sensor to transmit (see sensor instructions), according to the

device to be saved to memory.

In all four cases, the alarm will indicate the new device learning, by one led

flashing.

Repeat the procedure to save to memory other devices.

Turn the ignition “OFF”.

The procedure completion will be indicated by one flash of the turn signal.

passive alarm activation must be disabled.

Press a previously learned remote control push-button or insert an already

coded electronic key in the specific receptacle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gemini 7590T2-1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info