Bedienungsanleitung General Electric GTD86 (Seite 16 von 36) (Englisch, Spanisch)

646564

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Before you call for service…

Problem Possible Causes What To Do

Small amount of water Inadequate load size for steam • If using the Steam Dewrinkle cycle, manually reduce time

on floor in front of dryer cycle selected, excess steam or select fewer number of garments with Steam Select.

condenses inside cabinet and If using the Steam Refresh cycle, add more garments to

leaks out the load.

Water on floor in back Loose water hose connection to • Tighten connection.

of dryer valve

Hose missing rubber washer at • Install rubber washer provided with hose.

connection with valve

Water drips from door Steam condenses on inner door • This is normal.

when opened after

a Steam Cycle

Cannot see steam at Steam released at different • This is normal.

beginning of cycle time in cycle

Cannot see steam at any The steam nozzle might be • Call 800.GE.CARES to order nozzle replacement kit WE25M71

time during the cycle clogged with debris from your or to request a service technician to replace this for you.

water supply

Garments still wrinkled Too many garments • Load fewer garments; manually increase time.

after steam cycle

Garments are wet after Lint filter not clean • Clean lint filter

Steam cycle

Load is children/infant garments • Use the Steam Refresh cycle.

No numbers displayed Dryer is continuously • This is normal. When the dryer senses a low level of

during cycle, only lights monitoring the amount of moisture in the load, the dryer will display the dry time

moisture in the clothes remaining.

Time Remaining The estimated time may change • This is normal.

jumped to a when a smaller load than usual

lower number is drying

Dryer is running but The Extended Tumble option/ • This is normal. During Extended Tumble option/Steam Refresh

000 is displayed in Steam Refresh cycle was cycle, the time remaining is not displayed. The extended

Time Remaining chosen tumble option lasts approximately 60 minutes.

Clothes are still wet The door was opened mid-cycle. • A dry cycle must be re-selected each time a new load

and dryer shuts off The load was then removed from is put in.

after a short time the dryer and a new load put in

without selecting a new cycle

Small load • When drying 3 items or less, choose Speed Dry or Timed Dry.

Load was already dry except • Choose Speed Dry or Timed Dry to dry damp collars

for collars and waistbands and waistbands. In the future, when drying a load with

collars and waistbands, choose More Dry.

Dryer is not level • Move dryer to an even floor space or adjust leveling legs

as necessary until even.

Dryer turns off Very small load (such as one item) • Use the Timed Dry cycle option, select the desired dry time.

is not activating the dry sensor

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

General Electric GTD86 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info