Bedienungsanleitung Geonav 6 SUNSHINE (Seite 15 von 29) (Englisch)

522267

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

offered by Busse-Yachtshop.com

EnglishEnglish

GETTING STARTED

We recommend that you use the GEONAV intuitively, since

no damage will be caused by pressing an incorrect button.

Make sure that the unit is powered,

insert a CompactFlash™ cartridge and

then press PWR. At start-up, the last

chart used will be loaded by default. If

the chart is not found, the list of

NAVIONICS charts stored into the

CompactFlash™ cartridge will be dis-

played. Select the desired chart by the

CURSOR key, then confirm by pressing

ENTER.

A message will warn the user that electronic nautical charts

do not replace official government charts.

Press the PWR key to turn the display backlight on and adjust

brightness by the CURSOR key; press PAGE to continue.

The Satellite window will show the configuration of the sat-

ellites in use.

As soon as the GPS receiver has obtained a valid fix (it can

take a few minutes), the boat’s position and the relevant area

will be displayed at the best scale available.

The default language is English. To change the language, press

PAGE to display the menu, then select SETUP, LANGUAGE

and the desired language by the CURSOR key.

The line, or vector, starting from the boat indicates the boat’s

direction, to be ignored if the boat is stationary.

The window situated in the lower part of the screen will

display the boat’s speed, route and chart scale.

The GEONAV is in Navigation mode; by pressing the CURSOR

Getting Started

20m: areas with depths up to 10 meters in dark blue, up to

20 meters in blue

The areas whose depths are over the limit set, and therefore

navigable under safety conditions, will be displayed in white.

Dryline areas are always displayed in green.

NOTE: The mentioned colors are those used in the DAY mode. In NIGHT mode, the

areas with depths over the limit set, and therefore navigable under safety conditions,

are in black, whereas the colors below the limit are dark blue for higher depths and

blue for lower depths (e.g., 5m: areas with depths up to 2m displayed in blue, up to

5m in dark blue).

Chart loading

At start-up, the list of the NAVIONICS electronic charts stored

in the cartridge is shown, provided that a CompactFlash™

cartridge has been inserted.

Select the chart desired by CURSOR, then confirm by ENTER.

Each time the unit is switched on, the latest chart used will

be loaded.

To load another chart stored in the CompactFlash™. press

PAGE to display the menu, select SETUP and then SELECT

CHART.

Contrast/Brightness

Press the PWR key to display the CONTRAST/LIGHT win-

dow. To switch from one option to the other and to adjust the

contrast/brightness level, press CURSOR. Press the PAGE key

to exit.

The contrast can be adjusted at start-up, when the WARNING

message appears or when the satellite window is displayed;

press the ZOOM key and adjust the contrast.

Functional Characteristics

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Geonav 6 SUNSHINE Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info