Bedienungsanleitung Germania ECO 46 - 5300 (Seite 13 von 16) (Deutsch, Englisch)

620321

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Area of use

Cutting and collection

Grass is collected to the grass catcher (catcher capacity is

reduced if grass is moist or wet). To fasten the grass catcher

to the mower, lift the cover plate and fit the grass catcher.

Cutting (without grass catcher)

The cut grass is left in stripes.

GAS CONTROL

Self-propelled movement is controlled as follows: press the

automatic switch-off clip (10) towards the handle and the gas

lever (11) towards the handle at the same time.

To stop the forward movement, release the gas lever (11).

CUTTING HEIGHT ADJUSTMENT

The wheels height must be adjusted depending on the required

cutting height. Using the lever (8), adjust the height as required.

The medium position is ideal for most of the mowers.

ADDING OIL BEFORE STARTING THE APPLIANCE

Oil level must be checked every time the appliance is to be

used. Add oil (500ml SAE30 engine oil) if necessary.

Your mower is supplied without oil in the engine.

WARNING: Make sure the engine oil does not overflow as

the absorber would smoke when the appliance is started.

1. Make sure the mower is standing on a level surface.

2. Remove the cap off the oil tank.

3. Insert and attach the oil gauge.

IMPORTANT:

• Check the oil level every time the appliance is to be used.

Add oil to the gauge level marking if necessary.

• Change oil after 25 hours of operation or after the season

is over. Oil may need to be changed more often in a dusty

or dirty environment, see the “OIL CHANGE” in the

Servicing Section in this manual (SAE 30).

ADDING FUEL(unleaded)

• Fuel is added through the filling hole in the tank. Make

sure fuel is not spilled. Use common pure unleaded fuel.

Mix the fuel with oil. Buy only adequate fuel volume so that

it can be consumed within 30 days.

WARNING: Spilled oil or fuel to be wiped off. Not to

be stored, spilled, used near open fire.

WARNING: Alcohol-enriched fuels (gasohol) or fuels with

ethyl alcohol or methanol mixtures may attract humidity and

subsequent acid formation. Due to long storing, pure fuel

may damage the engine fuel system. To prevent engine

problems, you should empty the fuel system before storing

the appliance for more than 30 days. Empty the fuel tank,

start the engine and let it run until the fuel system and

carburettor are empty. Add fresh fuel each season. See the

storing instructions, too. Never pour cleaners to the fuel tank

to clean the engine or carburettor. By doing so, you could

cause irrevocable engine damage.

STARTING THE ENGINE

When starting the appliance, first make sure the spark plug is

in place and there is sufficient amount of oil and fuel in the

appliance.

Caution: The engine may smoke when the appliance is started

for the first time, which is caused by the protective oil film on the

inside surface of the engine. Take this as normal.

1. Press the primary pump (13) 3-5 times.

2. Press the automatic switch-off clip (12) towards

the sliding handle (1).

3. With the automatic switch-off clip (12) engaged,

pull out slowly the starting cord (9) until you can feel slight

resistance and then pull strongly the starter until the engine

starts.

Caution: The first steps may need to be repeated several

times in cold weather or when the appliance has not been

operated for a long time.

STOPPING THE ENGINE

To stop the engine, release the automatic switch-off clip (12).

CAUTION: The knife keeps rotating for a couple of

seconds after the engine has been switched off. To leave

the mower unattended, disconnect the spark plug cap.

Important tips and advice for cutting grass!!!

• Adjusting a bigger cutting height may be necessary under

certain conditions, e.g. grass being too high, to relief the

strain when pushing the mower, remove engine overloading

and prevent grass from getting stuck in the mower. It is

possible that the area will need to be cut more times.

• Vent ports in the grass catcher may get blocked if the catcher

is not cleaned regularly. Clean the grass catcher regularly with

water and let it dry before applying it.

• Keep the upper part of the engine at the starter clean. This will

improve the air flow and increase the engine service life.

• Cut in dry weather only.

• Keep the knives sharp at all times.

SERVICING

IMPORTANT – Regular servicing is absolutely necessary for

constant operational reliability and maintaining the original

appliance performance.

Original spare parts are supplied by the customer service

centre and dealers. An authorised service centre is

recommended to provide the annual servicing and inspection

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Germania ECO 46 - 5300 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info