Bedienungsanleitung Germania ECO 46 - 5300 (Seite 14 von 16) (Deutsch, Englisch)

620321

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

of the safety elements. Please contact your dealer for

servicing and spare parts.

1) Keep all bolts and nuts tightened to be sure that the

appliance is in an operation-reliable condition. Regular

servicing is necessary to provide safety and trouble-free

operation.

2) Never keep the appliance with fuel in closed rooms as the

evaporating fuel could ignite.

3) It is necessary to let the appliance cool down and empty

the fuel before keeping the mower in closed rooms.

4) To minimise the risk of fire, keep the engine and muffler

and the fuel tank clean and with no grass, leaves and fats.

Do not store the mower with the cut grass.

5) For safety reasons, avoid using the appliance with

any parts that are worn or damaged. Replace any

defective parts with new ones, do not repair them.

Original spare parts and original spare knives to be

used only.

Parts of quality other than specified may damage the

appliance and put your safety at risk.

6) If it is necessary to empty the fuel tank, do it outdoors and

with the engine being cold.

7) Wear solid protective gloves when disassembling and

servicing the knives.

8) Check the appropriate rotating direction and balance of

the knives after sharpening.

9) Check regularly the wear and pollution of the self-closing

cover and grass catcher.

10) Wear safety gloves whenever the appliance needs to be

transported, held in hands or inclined.

At all times, hold the appliance for parts guaranteeing safe

holding. Consider the mower weight and weight distribution.

CLEANING

Wash the appliance thoroughly with water before it is used,

remove any grass and mud from inside – this will prevent dirt

from drying inside the appliance and problems the next time the

appliance is started.

One or two times a year, remove the gear housing and use a

brush or compressed air to clean the space around the belt

pulleys and drive belts.

Once in a season, you should clean the inside of the driving

wheels. Disassemble both wheels. Remove grass and dirt off

the geared wheels and their edges using compressed air or a

brush.

KNIFE DISASSEMBLY

To clean/sharpen/replace the knife

CAUTION: The spark plug must be disconnected before

disassembly.

Release the bolt when disassembling the knives.

Reassemble as shown in the picture. Tighten the bolts. Torque -

40 Nm. The bolt should also be replaced when replacing the

knives.

OIL CHANGE

The oil drain plug is located under the engine. Make sure

there is a container to collect the oil and remove the plug. As

soon as all the oil has flowed out, fit in a new plug with a

washer and wipe any oil remnants.

Add new SAE30 oil to the tank. Check the oil level with a

clean gauge. The oil must reach between min. and max. level

marking on the gauge. Make sure the tank is not overfilled.

Start the engine and let it run for a short time. Then switch it

off, wait for a minute and check the oil level. Ad some oil if

necessary.

Spark plug

As soon as the engine has cooled down, remove the spark

plug with the supplied wrench, clean it with a wire brush and

adjust the distance to 0.75 mm (0.030") using a feeler gauge.

Refit the spark plug. Make sure it is not tightened too much

(alternatively: (Bosch WR 7 DC); (NGK BPR 6 ES))

Air filter

Loosen the filter cap and remove the foam filter element. To

prevent a foreign item from getting to the suction inlet, refit the

filter cap.

EMPTYING THE FUEL TANK AND CARBURETTOR

Put a container allowing fuel storage under the carburettor. To

prevent fuel spilling, use a funnel.

Remove the drain bolt and put the fuel valve tie rod to the ON

position.

Re-fit the drain bolt with a gasket ring when the fuel tank is

empty. Tighten the bolt.

Oil drain bolt

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Germania ECO 46 - 5300 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info