Bedienungsanleitung Gorenje ect 680 al (Seite 14 von 18) (Englisch)

335437

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Instructions for use, mounting and connection

Control elements

Once the glass ceramic hob is connected to the

mains (including the power failure), the appliance

will perform the process of initial synchronization

with the exterior environment, in order to provide

the most efficient sensor function and render the

best control.

After the successful accommodation to the

environment had been completed, the indicators

show the mark "-" for a moment which eventually

disappears.

The sound signal confirms the appliance is now

ready for use.

Do not place any objects upon the sensor surface

during the accommodation period, otherwise you

may provoke error mode. In such cases the

process is interrupted and all indicators display

the symbol ''F''. The hob fails to respond to

commands.

The hob is equipped with electronic sensors

which are switched on by touching or pressing the

relevant sensor surface with your fingertip.

Each sensor reaction is confirmed by the beep.

Be sure to always touch only one sensor at the

time, and for a very brief period of time

(approximately 1 second). If more than one

sensor is pressed at the same time the relevant

command is not accepted. If the touch is

prolonged it provokes error mode and the

appliance is switched off.

Do not place any objects upon the sensor surface

(error mode) nor any hot dishes which may

damage the sensors. Keep the sensor surface

clean at all times.

Switching the hob on

When the hob is turned off all the hotplates are

off and indicator LED's are off.

To switch the hob on, touch the ON/OFF sensor.

The hob is activated and the hob #4 power

display indicates flashing »0« for a period of 10

seconds. Other hob indicators are not illuminated.

In case the main ON/OFF sensor was pressed for

more than 2 seconds, the hob is switched off and

needs to be restarted. Using the (+) or (-) sensor

you may select the desired cooking power in 10

seconds following the switch on or selection of a

particular hotplate.

Selecting the particular hotplate

Once the hob is switched on with the ON/OFF

sensor, activate the hotplate selection sensor to

select the next hotplate in the clockwise direction,

always starting with hotplate #4. The indicator

flashes 10 seconds after the hotplate and its

power setting are selected. Active hotplate is

indicated by flashing power setting. By touching

the (+) sensor you select setting "9" and activate

automated cooking mode. Current setting may be

reduced by touching the (-) sensor in short

intervals. Prolonged pressing speeds up the

setting reduction. If you switch the hotplate on by

touching the (-) sensor, the power selection

indicates "4". This setting may then be increased

or reduced by pressing either (+) or (-) sensor

and select the desired heating power.

If the hotplate selection sensor is touched once

again, you select the next hotplate in clockwise

direction, and this is signaled by flashing of the

indicator.

If only one hotplate is activated, by pressing the

hotplate selection sensor this hotplate is selected

directly. In case more than one hotplate is active,

the first one to be activated is always hotplate

#4.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje ect 680 al Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gorenje ect 680 al

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info