Bedienungsanleitung Gorenje HEC50PP (Seite 26 von 26) (Englisch)

512707

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Instructions for Use

Leveling the cooker

The height of the cooker with the support is 90

cm, and without support it is 85 cm. Left and right

side of the support is equipped with two wheels to

facilitate relocation. In the front part, on both

sides there are two adjustable screws, used to

level the cooker and adjust its upper edge in line

with the adjacent kitchen furniture.

Adjustable legs are accessible when the drawer

is pulled out. Adjust the position of the cooker by

turning the legs in one direction or another.

Adjustable legs will be turned easier if the

appliance is somewhat lifted up and tilted.

Drawer

The drawer is protected against accidental

opening. If you want to open the drawer slightly lift

it first and then open it. In case you want to

remove it from the appliance pull it out until it

stops, lift it and again pull it out.

Never store inflammable, explosive or heat

sensitive material in the drawer.

Place the storage drawer by inserting the rear

bottom slide into the cooker guides.

Instructions for Connection

Important Warning

• Before any intervention, disconnect the power

supply. Considering the mains voltage the

appliance should be connected in accordance with

one of the following connecting possibilities.

Protective conductor (PE) must

be put on terminal pin

• Connection should be performed by qualified fitter

only.

• Before attempting to connect the appliance check

wheter the voltage indicated on rating plate

corresponds to mains voltage.

• The rating plate of the cooker containing general

data is at the edge of the oven and is visible when

the door is open

• When the appliance is connected to power supply

switch on all heating elements for about 3 minutes

in order to check their operation.

• The electric installation should have switching

device that disconnects the aplliance from mains

in any pole. In open position the distance between

contacts should be at least 3 mm. LS switches

and fuses are considered to be good protection.

• This appliance can be connected to three-phase

or two-phase power supply 3N AC

400 V with neutral conductor, but may as well be

conected to AC 230V.

• When selecting the connector, consider the

capacity of the power supply and fuses. Supply

cord should be directed through relief device

which protects the cord against accidental pulling

out.

• Terminal pins are accessible when you remove

the rear wall of the appliance.

• The following can be used for connection:

− rubber connection cables (type HO 5RR-F

with green-yellow protective conduit)

− PVC insulated connection cables (type

HO 5VV-F with green-yellow protective

conduit) or

− any other suitable cable of equal or better

properties.

Connection Terminal

Bridges are inserted between connectors N-N on

terminal pin.

WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE

ON THE OPERATION OF THE APPLIANCE.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje HEC50PP Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info