Bedienungsanleitung Gorenje K57CLB1 (Seite 10 von 13) (Englisch)

728634

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

EN 9

IMPORTANT PRECAUTION

In case of left side connection (seen from the front)

the hose must be connected by means of a clamp

fixed in the back cover opening. You will find the

fixing clamp in the accessory kit.

CONNECTION TO THE NATURAL GAS

NETWORK

Connection must be made in accordance with

standing local regulations. In case of excessive gas

pressure use pressure regulator.

CONNECTION TO THE LPG NETWORK

Special LPG coupling must be installed at the 1/2"

pipe connection.

1. Connection ending

2. Knee

3. Connection hose (connection from the right)

4. Connection hose (connection from the left)

5. Fixing clamp

6. Back cover of the cooker

IMPORTANT PRECAUTION

In case of left side connection (seen from the front)

the hose must be connected by means of a clamp

fixed in the back cover opening. You will find the

fixing clamp in the accessory kit.

CONNECTION TO THE MAINS POWER

NOTE

The combined cooker is a Class I appliance

according to the electric shock prevention degree

and must be connected to the earthed mains power

installation. The connections must be carried out by

qualified personnel only.

 The appliance is fitted with power cord plug for

connection to the mains.

 For appliances exceeding 2 kW of power it is

recommended to use extra feed circuit with a 16A

circuit breaker.

 Power socket to which the appliance is connected

must be accessible at all times.

 Faulty power cord must be immediately replaced

with a new one.

CAUTION

Make sure that the power cord is installed in such

way to avoid touching hot parts of the cooker

(exhaust at the back side, bottom part of the hob).

High temperature could cause damage to the

insulation.

BURNER SETTINGS

MINIMUM OUTPUT ADJUSTMENT

Before starting any adjustments disconnect the

appliance from the mains power supply.

Adjustments must be carried out with the tap at the

"SAVING" position.

The minimum gas output is correctly adjusted when

the inner cone of the flame arrives at the height of 3

to 4 mm.

If this is not the case, first remove the tap knob and

then tighten or loosen the screw C, depending on

whether the flame is to be reduced or increased.

For butane/propane the screw C must be fully

screwed in.

Burner

Small

Medium

Rapid

Input power (kW)

1,0

1,75

2,7

Natural gas G 20 – 20 mbar

Nozzle diameter

(mm)

0,77

1,01

1,22

Natural gas G 20 – 13 mbar

Nozzle diameter

(mm)

0,83

1,12

1,37

Propane-butane G 30 – 30 mbar

Nozzle diameter

(mm)

0,50

0,66

0,83

Nominal flow (gram

/ hour)

72,8

127,3

196,5

CONVERSION TO ANOTHER

TYPE OF GAS

Conversion of cooker to another type of gas can be

performed only by qualified technician.

Adhere to the following procedure:

 Change nozzles of all burners.

 Adjust or change gas pressure regulator if

installed.

 Adjust SAVING power position of hob.

 Stick new gas setting label with relevant nozzle

information.

 To conduct this operation, make the appropriate

entry in "The warranty card."

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje K57CLB1 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info