460594
9
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
9
GB
These variations will not affect the food
products and the temperature will quickly
return to the set-point level.
When the door of the freezer’s chamber
is open for more than 2 minutes the
display will show E4 alarm and the
acoustic alarm will be activated.
Alarm codes
E2 – temperature sensor fault in the
freezer’s chamber
E4 – door is open
E5 – too high temperature inside the
freezer’s chamber
E6 – too high temperature after the
power failure
E2
The temperature sensors has been
damaged. Call technical service. The
built-in emergency program maintains
the admissible temperature until the fault
will be eliminated by the authorized
technical service.
E4
The door of the freezer’s chamber has
been opened for more than 2 minutes.
The alarm code disappears when the
door is closed.
E5
The temperature inside the freezer’s
chamber has been exceeding the set
temperature for more than 2 hours.
E6
There has been the power supply failure.
The power supply has been
disconnected from the freezer and the
temperature inside the freezer’s
chamber is too high.
Interrupting an alarm
The acoustic alarm can always be
interrupted by opening the door and/or
pressing any push-button.
The alarm code E3 - E6 can be cancelled by
pressing for 7-8 seconds at the same time
the push-buttons (7) and (8).
The exception: in case of the alarm E1 it
is possible to cancel the alarm only after
replacing damaged sensors.
In case the display shows symbols E5 or
E6, it is possible to monitor the maximum
temperature recorded by the control
system by pressing the buttons 9 and/or
10. If the alarm is caused by a more
permanent defect the alarm code will
appear again but without the acoustic alarm.
In such cases please contact Gram Service
Center.
Display brightness adjustment
By pressing and holding the pushbutton
(9) and
- pressing at the same time the
pushbutton (7), the display
brightness increases,
- pressing at the same time the
pushbutton
(8), the display brightness
decreases.
When adjusting the display brightness,
the display shows the following
indications:
1.8 – minimum brightness
2.8 – medium brightness
3.8 – maximum brightness
(manufacturer’s setting).
Alarms
Normal use of the freezer may cause
different situations leading to interruption
of various functions and unstable
operation of the entire equipment as a
consequence. These interruptions are
shown on the display as the alarm code
(an E followed by a number) and
signalled by the acoustic alarm.
In case there will be several faults the
alarm codes shall be displayed in turn.
t t
t t
t
ss
ss
s
ss
ss
s
t t
t t
t
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gram FSD 23 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info