Bedienungsanleitung Graupner MC 22S (Seite 162 von 180) (Englisch)

467112

162

Zoom out

Zoom in

Vorherige Seite

1/180

Nächste Seite

162

Opto-electronic Trainer system with light-pipe lead

Order No. 3289

This Trainer system enables you to transfer indi-

vidual functions, several functions or all the func-

tions to the Pupil transmitter. The set is designed

for expanding the mc-22s transmitter for use as a

Teacher transmitter.

Notes:

The Teacher transmitter must be ﬁ tted either with

an adaptor, Order No. 4184.1, or the mc-22(s) in-

terface distributor, Order No. 4182.3, to allow the

Trainer module contained in this set to be connec-

ted to the mc-22s transmitter.

A momentary switch, Order No. 4160.11, or a

kick button, Order No. 4144, is required as a safe

means of transferring control.

If individual functions are to be transferred, the

functions are selected in the »Teacher/pupil«

menu (see page 115) of the Teacher transmitter,

which may be operated using any of the four mo-

dulations PPM18, PPM24, PCM20 or SPCM20.

CAUTION:

In contrast to the Trainer system described here,

a low-cost Trainer system, Order No. 3290, can

only be used for Trainer mode operations in PPM

mode; this version also requires a Pupil transmit-

ter which is fully set up to suit the model.

Suitable pupil transmitters:

D 14, FM 414, FM 4014, FM 6014, mc-10, mc-12,

mx-12 mc-14, mc-15, mc-16, mx-16s, mc-16/20,

mc-17, mc-18, mc-19, mc-20, mc-22, mc-22s, mx-

22 and mc-24.

The Pupil transmitter is always operated in its

basic (default) setting.

If the transmitter is an mc-series or mx-series

unit, select a model memory with the appropria-

te model type, assign it the “model name” of “Pu-

pil” and set up the stick mode to the suit the pupil

pilot’s preference. All other settings should be left

at their defaults. If the model type is “Fixed wing”,

the “Throttle min forward / back” in the “Motor” line

of the »Model type« menu should be set approp-

riately. If the model type is “Heli”, the throttle / col-

lective pitch direction and the idle trim should be

set to suit the pupil in the same way. All other set-

tings, such as mixer and coupling functions, are

carried out and transferred by the Teacher trans-

mitter.

If you are using a D 14, FM 414, FM 4014, FM

6014, FM 6014 / PCM 18 transmitter, you should

check the direction of servo rotation and stick

mode, and if necessary correct them by re-con-

necting the appropriate cables inside the transmit-

ter. Any mixers should either be switched off or set

to “zero”.

Connections in the mc-22s Teacher transmitter

Install the Teacher module in the transmitter case

at a suitable position. Connect the ten-pin plug at-

tached to the Teacher module to the adaptor, Or-

der No. 4184.1, or the interface distributor, Order

No. 4182.3.

The Trainer module, Order No. 3290.19, can be

connected directly to the interface on the transmit-

ter circuit board by means of the fourteen-pin con-

nector.

When you connect the Teacher transmitter to

a Pupil transmitter, locate the plug marked “M”

(Master) on the Trainer lead and connect it to the

Teacher module.

See the next page for a connection diagram for

the Teacher transmitter.

Connections in the mc-22s Pupil transmitter

Disconnect the connecting lead from the Pupil

module (it is not required with these transmitter ty-

pes).

Install the Pupil socket in the transmitter case in a

suitable position. Disconnect the four-pin connec-

tor attached to the RF module, and plug it into the

four-pin Pupil socket.

See the next page for a connection diagram for

the Pupil transmitter.

Teacher module for individual channel trans-

fer, mc-22(s) / mc-24

Order No. 3290.2

This expansion module is used to upgrade the

opto-electronic Trainer system, Order No. 3290, to

form a professional Trainer system with individu-

al channel transfer. To connect the module the mc-

22s transmitter must already be ﬁ tted with the in-

terface distributor, Order No. 4182.3, or with the

mc-22(s) / mc-24 adaptor, Order No. 4184.1.

Teacher module for mc-19 / mc-22(s)

Order No. 3290.19

In contrast to the module, Order No. 3290.2, this

Teacher module features a fourteen-pin connector,

so that it can be connected directly to the transmit-

ter circuit board using the fourteen-pin interface.

Appendix

Trainer system with light-pipe lead or Eco lead Accessories

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Graupner MC 22S Seite 162

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info