467070
21
Zoom out
Zoom in
Vorherige Seite
1/33
Nächste Seite
4140
ï Protect batteries from vibration, and do not subject them to mechanical stress or shock.
ï Batteries can generate explosive gas (hydrogen) when on charge and when being discharged, so it
is important to provide good ventilation
ï Do not allow batteries to come into contact with water - explosion hazard.
ï Never short-circuit battery contacts - explosion hazard.
ï Do not open battery cells - corrosion hazard.
ï It is best to “balance”, or even up, the cells in NiCd and NiMH battery packs by first discharging all the
cells separately and then charging up the pack. Individual cells can be discharged using the charger
or they can be by “bridged” using a 100 Ohm resistor over each individual cell in the pack.
ï Please don’t be surprised if your batteries are not as willing to accept charge in Winter as in Summer.
The ability of a cold cell to accept and store charge is much lower than that of a warm one.
ï
Battery disposal: exhausted batteries are not ordinary household waste, and you must not dispose of
them in the domestic rubbish. The retail outlet where you purchase your batteries should have a
battery recycling container for proper disposal. Trade outlets are obliged by law to accept exhausted
batteries for disposal.
19. Specification
Akku
Charge current / charge power 100 mA to 5.0 A / max. 90 W
Discharge currents / discharge power 100 mA to 3 A / max. 20 W
Ni-Cd & NiMH batteries:
Cell count 1 - 25 cells
Capacity min. 0.1 Ah up to 4,0 Ah
Lithium batteries:
Cell count 1 - 7 cells
Battery cell voltage 3,6 V (LiIo) or 3,7 V (LiPo)
Capacity min. 0,2 Ah
Lead-acid batteries:
Cell count 1, 3, 6, 12 cells
Battery voltage 2, 6, 12, 24 V
Capacity min. 1 Ah
Charge current 100 mA to 5.0 A
Trickle charge current 50 - 250 mA
General:
Operating voltage range 11.0 to 15 V
Car battery 12 V, min. 30 Ah
Power supply 12-14V, min. 12 A stab.
No-load current drain approx. 120 mA
Low-voltage cut-off approx. 11.8 / 10.5 V
Weight approx. 520 g
Dimensions approx. (W x D x H) 130 x 113 x 40 mm
All data assume a car battery voltage of 12.7 V.
The stated values are guidelines, and may vary according to battery state, temperature etc.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. We reserve the right to introduce modifications.
The charger is entirely maintenance-free in use, and requires no maintenance of any kind. However, it
is in your own interests to protect the unit from dust, dirt and damp.
To clean the charger disconnect it from the car battery and any other battery, and wipe it clean with a dry
cloth (don’t use cleaning agents!).
17. Cleaning and maintenance
___________ _____
___________ _____
*****ERROR *****
contact break
___________ _____
___________ _____
*****ERROR *****
time limit over
18. Notes on handling rechargeable batteries
ï Charging single NiCd or NiMH cells, and packs consisting of 1 ... 4 cells, presents the automatic
charge termination circuit with a difficult task. The voltage peak is quite small in such cases, and it
cannot be guaranteed that the cut-off circuit will work reliably. The automatic circuit may not be trigge-
red, or may not terminate at the correct time. For this reason it is important to carry out a series of
monitored test charge processes with single cells or small packs in order to establish whether the
charge is terminated reliably.
ï Warm batteries offer much higher performance than cold ones, so don’t be surprised if your batteries
don’t seem so effective in the Winter.
ï Overcharging and deep-discharging batteries leads to irreparable damage to the cells, and perma-
nently reduces their maximum performance and effective capacity.
ï Never store batteries for a long time in an uncharged, discharged or part-charged state. Before storing
your batteries charge them up and check their state of charge from time to time.
ï When purchasing batteries we recommend that you only buy good quality products. Start by char-
ging new packs at low rates, and work up gradually towards higher currents.
ï Batteries should not be charged up until shortly before use, as they are then able to give you their
best performance.
ï Do not solder directly to battery cells. The temperatures which occur during soldering can easily
damage the seals and safety valves of the cells. If this should happen, the battery may lose electro-
lyte or dry out, and some of its potential performance will be lost.
ï Charging and discharging any battery at high currents shortens the life expectancy of the pack. Don’t
exceed the maximum values stated by the manufacturer.
ï Overcharging inevitably reduces the capacity of the battery, so do not recharge a hot battery, or one
which has already been charged.
ï Lead-acid batteries are not capable of being charged at high currents. Never exceed the charge
currents stated by the battery manufacturer.
If the charger detects an interruption of the connection bet-
ween battery and charger during a charge / discharge pro-
cess, the screen displays this error message.
If you see this error message when the charger is in use, it
may indicate an intermittent contact.
Note: the same error mes-
sage also appears if you deliberately break off the charge pro-
cess, e.g. by disconnecting the charge lead.
If a charge process continues to the end of the safety charge
timer period, the process is shut down in the interests of safety.
Possible causes: charge current too low - battery not fully char-
ged; charge leads too thin and/or too long - charge current
cannot be raised to sufficient level, battery capacity too great.
___________ _____
___________ _____
*****ERROR *****
wrong polarity
This warning message is displayed if the unit’s charge outputs
are connected to a battery with incorrect polarity.
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Graupner Ultramat 17 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Graupner Ultramat 17

Graupner Ultramat 17 Bedienungsanleitung - Holländisch - 18 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info