Bedienungsanleitung Greenworks G24LT30 - 21227 (Seite 5 von 160) (Alle Sprachen)

708341

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

English

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

Only the parts shown on the parts list are intended to

be repaired or replaced by the customer. All other parts

should be replaced at an Authorised Service Centre.

CHARGER AND BATTERY PACK

29697/29807- 24V 43Wh Lithium battery pack

29837- 24V 86Wh Lithium battery pack

29817/29827- 24V charger

BATTERY PACK REMOVAL AND PREPARATION FOR

RECYCLING

Contact customer service for the latest replacement parts

and accessories.

WARNING

Upon removal, cover the battery pack’s terminals with

heavy-duty adhesive tape. Do not attempt to destroy

or disassemble battery pack or remove any of its

components. Lithium-ion and nickel-cadmium batteries

must be recycled or disposed of properly. Also, never

touch both terminals with metal objects and/or body

parts as short circuit may result. Keep away from

children. Failure to comply with these warnings could

■Install the new spool so that the cutting line and slot

align with the eyelet in the cutting head. Thread the

cutting line into the eyelet.

■Pull the cutting line extending from the cutting head

so the cutting line releases from the slot in the spool.

■Reinstall the spool cover by depressing tabs into slots

and pushing down until spool cover clicks into place.

CUTTING LINE REPLACEMENT

See Figures 12 - 13.

■Remove the battery pack.

EN DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET

SPOOL REPLACEMENT

See Figure 12.

Use original manufacturer’s replacement cutting line for

best performance.

■Remove the battery pack.

■Push in tabs on side of spool cover.

■Pull spool cover up to remove.

■Remove the old spool.

■To install the new spool, make sure the cutting line is

captured in the slot on the new spool. Make sure the

end of the cutting line is extended approximately 15cm

beyond the slot.

■Remove the spool from the cutting head.

NOTE: Remove any old cutting line remaining on the

spool.

■Cut a piece of cutting line approximately 3m long. Use

only 1.65mm diameter monofilament cutting line.

■Insert the cutting line into the anchor hole in the upper

part of the spool. Wind the cutting line around the upper

part of the spool clockwise, as shown by the arrows on

the spool. Place cutting line in the slot on upper spool

flange, leaving about 15cm. extended beyond the slot.

Do not overfill. After winding the cutting line, there

should be at least 0.635 cm between the wound

■Replace the spool, and the spool cover. Refer to spool

replacement earlier in this manual.

STORING THE TRIMMER

■Remove the battery pack from the trimmer before

storing.

cutting line and the outside edge of the spool.

■Clean all foreign material from the trimmer.

■Store it in a place that is inaccessible to children.

■Keep away from corrosive agents such as garden

chemicals and de-icing salts.

■Store and charge your batteries in a cool area.

Temperatures above or below normal room

temperature will shorten battery pack life.

■Never store batteries in a discharged condition. Wait

for battery pack to cool and fully charge immediately.

■Store the battery pack where the temperature is below

27˚C and away from moisture.

■All batteries gradually lose their charge. The higher the

temperature, the quicker they lose their charge. If you

store your unit for long periods of time without using

it, recharge the batteries every month or two. This

practice will prolong battery pack life.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Greenworks G24LT30 - 21227 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info