Bedienungsanleitung Grizzly EKS 1835 QT (Seite 148 von 200) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Polnisch)

505393

148

Zoom out

Zoom in

Vorherige Seite

1/200

Nächste Seite

148

• The saw chain must not contact either

the ground or another object during

sawing through or after sawing com-

pletion.

• Make sure that the saw chain does not

become jammed in the wood. Do not

let the tree trunk break or split off.

• Consider also the precautions against

spring-back (see notes on safety).

 

do not attempt to pull out the







-



Bucking

This refers to sawing up a felled tree trunk

into smaller sections.

• Ensure that the saw chain does not

come in contact with the ground during

sawing.

• Make sure you have a secure stance

and, in the case of sloping ground,

stand above the log.

1. Log is lying on the ground:

Saw through the log completely

from above and ensure at the

end of the cut not to contact the

ground.

If you can turn the tree trunk, saw

two-thirds of the way through it.

Then turn the trunk around and

saw the rest of the way through

from above.

2. Log is supported at one end:

Start sawing from the bottom and

work your way up (with the upper

edge of the bar) a third of the way

If no trace of oil appears, it may

be necessary to clean the oil out-

let channel or to have the electric

chainsaw repaired by our customer

service.

Sawing techniques

General

Observe the noise protection and lo-

cal regulations when cutting wood.

Local requirements may require a

suitability test. Ask the forestry com-

mission.

• Dirt, stones, loose bark, nails, staples

and wire must be removed from the tree.

• For sawing work on a slope, always

stand above the tree trunk.

• To keep control at the moment of

“sawing through”, reduce the contact

pressure at the end of the cut without

loosening the rm grip on the chain-

saw handles. Ensure that the saw

chain does not come into contact with

the ground.

• After completing the cut, wait for the

chainsaw to come to a standstill be-

fore removing the chainsaw.

• Always switch off the chainsaw motor

before moving from one tree to an-

other.

• Lay the connecting lead such that

it will not be caught on branches or

similar during sawing.

• For each cut, apply the claw stop se-

curely and only then start sawing.

• You have better control when you saw

with the bottom side of the chain bar

(with pulling saw chain) and not to

with the top side of the chain bar (with

pushing saw chain).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grizzly EKS 1835 QT Seite 148

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info