Bedienungsanleitung Grohe 39141 (Seite 7 von 14) (Deutsch, Englisch, Holländisch, Polnisch)

759360

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Automatic flushing (72 Hours) activate/deactivate

Maintenance, see Fig. [14] and [15].

• Shut off water supply

• Inspect and clean all components and replace if necessary

A nearly discharged battery is indicated by 2 beep sounds

after pressing the transmitter button. Flushing is then initiated.

An empty battery is indicated by a beep sound every minute.

Flushing is no longer initiated.

Replacement parts, see fold-out page I (* = special

accessory).

Disposal note

Dispose of batteries in accordance with national

regulations!

The flow volume can be changed within 20 seconds of

flushing (if necessary) by pressing the button again. The

selected flush setting is stored if the button is not pressed

again within 20 seconds of flushing.

1. Activate registration mode by pressing button (A), see

Fig. [10].

Indicator lamp (B) displays:

██

2. Repeat pressing and holding button (A).

Indicator lamp displays:

▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌_____▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌_____████

3. When ████ appears, release button.

4. Button pressed for the first time (within 2 seconds)

Indicator lamp displays:

██ ██ ██ ██ Automatic flushing activated

Button pressed for the second time (within 2 seconds)

Indicator lamp displays:

██████ ██████ Automatic flushing deactivated

Each press of the button switches between the two states.

The selected setting is stored if the button is not pressed

again within 10 seconds of flushing.

Fault/ Cause / Remedy

Fault Cause Remedial action

No flushing after the radio

transmitter has been actuated

• Water supply interrupted - Open isolating valve in cistern

• Radio transmitter not registered - Registering a radio transmitter

• Batteries in radio receiver unit are empty

(a beep is sounded every minute)

- Replace batteries

• Servo motor defective (no rotation) - Replace radio receiver unit

• Radio transmitter is too far away - Install radio transmitter within

transmission range (10 m)

• Battery in radio transmitter is discharged - Replace battery in radio transmitter

Water flowing continuously • Outlet valve not closing - Repair or replace outlet valve, see

instructions for cistern

• Servo motor defective (lever does not

return to end position)

- Replace radio receiver unit

Undesired flushing • Adjacent radio transmitter unintentionally

registered

- Delete all radio transmitters and re-

• Automatic flushing activated - Deactivate automatic flushing

Flow volume too low • Servo motor defective (incomplete

rotation)

- Replace radio receiver unit

• Residual flow rate too high - Push residual flow slider downwards

• Flow rate in cistern too low - Turn float of filler valve further upwards

2 beeps sound after the radio

transmitter has been actuated

• Batteries in radio receiver unit are nearly

discharged

- Replace batteries

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grohe 39141 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info