788793
62
Zoom out
Zoom in
Vorherige Seite
1/165
Nächste Seite
62
9) The robot lawnmower has rolled over
If the robot lawnmower rolls over, it stops automatically
and reports an error. Reposition the robot lawnmower
and press the OK button to start it again. If the error is
caused by a steep slope in the work area, change the
layout of the boundary wire to avoid the slope. Follow
the installation instructions.
10) The robot lawnmower has been overloaded
The robot lawnmower’s motor is protected against
overload. If this error occurs, it is probably because the
grass is too tall for the robot lawnmower, or the cutting
disc and the wheels are clogged with grass clippings,
mud, etc. If the grass is too tall, cut it with a regular
lawnmower and clean the robot lawnmower. Press the
OK button to re-start the robot lawnmower.
11) There is an obstruction on the boundary wire
If an obstruction on or near the boundary wire prevents
the robot lawnmower from reaching the charging
station, it tries a few times and then stops. Remove the
obstruction. Press the OK button to re-start the robot
lawnmower.
Other errors and troubleshooting
For some errors, an error code will not be displayed.
12) The robot lawnmower cannot be switched on at
the control panel
Check that the main switch (9) is in the ON position.
Carry the robot lawnmower to the charging station and
leave it to charge.
13) The robot lawnmower cannot reach the charging
station
Read the installation instructions and make sure that
the charging station is correctly positioned.
14) The robot lawnmower runs in circles along the
boundary wire
There is a live cable in the ground near the boundary
wire. Move the boundary wire.
If the robot lawnmower has registered the boundary
wire more than X times and has moved a few metres
away from the most recent registration point, it runs
around in a spiral trajectory to improve its coverage of
the lawn.
15) The robot lawnmower is very noisy
If the robot lawnmower makes more noise than normal,
check the following:
Arethebladesdamaged?
Change all the blades and screws at the same time.
Arethebladesblocked?
Remove any foreign objects (ropes, plastic, tape, etc.)
from the blades.
If there is noise from the motors that turn the cutting
disc or wheels, the robot lawnmower must be inspected
by a professional.
16) The LEDs on the control panel do not light up
Press and hold the POWER button (a) for 3 seconds to
switch on the robot lawnmower. If the robot lawnmower
does not switch on, you will need to carry the robot
lawnmower to the charging station and charge it
manually. (See the section “Manual charging”).
62

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Grouw 17937 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info