ķ
9
Your Unit at a Glance
Right Side of Unit
FINE TUNING Fine tuning
For fine tuning on SSB reception.
SSB SSW on/off switch
For switching on and off the SSB mode (Single Side
Band reception).
SSB is especially used for amateur SW radio recep-
tion.
TONE Tone control
Two positions: HIGH (treble) and LOW (bass).
VOLUME Volume control
Left Side of Unit
SW EXT.ANT Socket for external aerial
Aerial connection for SW reception. For external aeri-
al with 3.5 mm ø jack plug.
DX/LOCAL Sensitivity switch
Normal position is "DX" (distant reception).
If the signal is too strong resulting in reception inter-
ferences, set the switch to "LOCAL".
STEREO MONO On FM: Mono/stereo switch.
WIDE NARR On AM: Wide/narrow switch.
In the FM waveband, this switch is used to select
between mono and stereo reception.
In the AM wavebands, the same switch is used for
changing the bandwidth.
y Headphone/earphone socket
For headphone or earphone with jack plug of
3.5 mm ø (32 Ohm impedance). Connecting a head-
phone disconnects the built-in loudspeaker. For this
reason, the headphone must be disconnected
if you
wish to be woken up by the radio.
} DC socket
DC 9V For connecting a commercial plug-in mains unit with
coaxial plug (outer diameter 5.5 mm, inner diameter
2.1 mm; output voltage 9.0 V=; mains voltage
230 V ʋ
, 50/60 Hz; neutral conductor connected to
earth
}).
Rear of Unit
Swing-out support
Swing out this support to bring the unit into a tilted
position.
On the support there is an illustration showing the
time zones of the earth.
Below the support there is the type plate of the unit.
Battery compartment
For six 1.5V batteries (IEC LR6, UM-3).
