CONNECTION AND PREPARATION
__
Connecting the power supply unit
(SYS 1308-2412-W2E)
Note:
Always switch off the DVD player before connecting to or dis-
connecting from the mains.
Only use the power unit supplied. Using another power supply
unit could lead to malfunction and damage.
Unplug the power supply unit if you are not using it.
1 Plug the power supply unit into the »
DC IN 12V
« socket of the
DVD player.
2 Plug the power supply unit into the wall socket.
Note:
The only way to disconnect the device from the mains supply
is to unplug the adapter.
Activating the remote control battery
1 When using it for the first time, activate the remote control bat-
tery by pulling out the film protruding from the battery holder.
Note:
Do not expose the remote control and the battery to extreme
heat.
Changing the remote control battery
1 Pull out the battery holder.
2 When inserting the battery (3 V, lithium), make sure the positive
terminal (+) is facing upwards.
3 Push the battery holder back into the remote control until it
latches into place.
Note:
If the DVD player no longer reacts properly to remote control
commands, the battery may be flat. Always remove used bat-
teries. The manufacturer accepts no liability for damage
caused by leaking batteries.
There is a risk of explosion if the battery is not replaced
properly. Only use the same type of battery or an equivalent.
Environmental note:
Batteries, including those which do not contain heavy metal,
should not be disposed of with household waste. Please dis-
pose of used batteries in an environmentally sound manner.
Find out about the legal regulations which apply in your area.
15
ENGLISH
