Bedienungsanleitung Grundig m 27 c (Seite 4 von 20) (Englisch)

157243

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

General Information

• The typeplate is located at the rear of the set.

• Recording is permissible if copyright or other

rights of third parties are not infringed.

1 All unnecessary packaging material has been

omitted. We have done our utmost to make

the packaging easy to separate into three

mono-materials:

– cardboard (box)

– expandable polystyrene (buffer)

– polyethylene (bags, protective foam sheet).

Please observe the local regulations

regarding the disposal of these packaging

materials.

2 Your set consists of materials which can be

recycled and reused if disassembled by a

specialized company. Please follow local

regulations on recycling your old set.

3 Do not dispose off dead batteries with your

household waste. Dispose off batteries

according to local regulations.

4 Note: Switching off the standby mode

overnight (remove the AC power cord from

the wall socket) will save energy.

The set is provided with a built-in ventilator.

To prevent overheating, this ventilator will be

switched on when the unit reaches a certain

temperature.

INTRODUCTION

M27 page 20

Safety Information

• Before operating the system, check that the

operating voltage indicated on the typeplate (or

the voltage indication beside the voltage selector)

of your system is identical with the voltage of your

local power supply. If not, please consult your

dealer. The type plate is located at the rear of

your system.

• When the system is switched on, do not move it

around.

• Place the system on a solid base (e.g. a cabinet).

• Place the system in a location with adequate

ventilation to prevent internal heat build-up in your

system.

• Do not expose the system to excessive moisture

(e.g. dripping or splashing), rain, sand or heat

sources.

• Under no circumstances should you repair the unit

yourself, as this will invalidate the warranty!

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,

moisture may condense on the lens of the CD unit

inside the system. Should this occur, the CD player

will not operate normally. Leave the power on for

about one hour with no disc in the unit until normal

playback is possible.

• Electrostatic discharge may cause unexpected

problems. See whether these problems disappear

if you unplug the AC power cord and plug it in

again after a few seconds.

• To disconnect the system from the power supply

completely, withdraw the AC power cord from the

wall socket.

Accessories (Supplied)

– Remote control transmitter

– Batteries (2 x AAA size) for remote control

transmitter

– AM loop antenna

– FM antenna wire

– AC power cord

Inserting the batteries into the

Remote Control

• Insert the batteries (Type R03 or AAA) into

the remote control transmitter as shown in the

battery compartment.

• To avoid damage from possible battery

leakage, remove dead batteries or batteries

that will not be used for a long time. For

replacement use type R03 or AAA batteries.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grundig m 27 c Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info