Bedienungsanleitung Gude BLACKLINE BL 560 E 95305 (Seite 15 von 63) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

626217

Zoom out

Zoom in

Vorherige Seite

1/63

Nächste Seite

FUEL TANK CAP

thrown up but ground by the cutting knives and the grass

will remain as surface fertilisation on the lawn

2. Cutting and collecting

The grass is collected to the grass catcher (if the grass

is damp or wet it reduces the catcher capacity). If you

want to mount the catcher to the mower lift the cover

plate and hang the grass catcher.

3. Cutting (without grass catcher)

The cut grass is laid in strips.

4. Cutting (side ejection)

Hewed long grass lies down in the strips. Loose screw (Fig.

1/15), pull part of side ejection out and then screw. (Fig. 1/15)

tighten again (Fig. 6)

Changeover to mulching

1. Assembly and disassembly of accessories must always

take place when the engine is switched off.

2. Remove the grass catcher, insert the mulching wedge to

the ejection channel and lock the mulching wedge (1) point it

against two outlets (2) in the bottom part and ensure it with a

self-securing hook (3).

3. Please make sure the mulching wedge is mounted firmly

after the changeover.

4. Attention!!! Use original equipment from the producer

only.

5. Disassembly

Press with thumb in the middle (3) then release and deflect

the mulching wedge downwards.

Attention!!!

If the mower is blocked during mulching reduce the

travelling speed so that the knife could continue in

grinding the grass and spread it on the lawn. Never

remove the gathered grass with your hands.

DRIVE CONTROL

The self-propelling travel is controlled as follows: Press the

lever for automatic stopping (12) towards the handle and

simultaneously press the drive lever towards the handle (13).

The forward movement is stopped by releasing the drive lever

(13).

CUTTING HEIGHT ADJUSTMENT

Depending on the cutting height required it is necessary to

adjust the height of wheels. Adjust the height with the lever (8)

as you wish. The middle position is most suitable at most

mowers.

ADD OIL BEFORE STARTING

The oil level needs to be checked before each use. Fill up oil

as needed (500ml SAE30 engine oil).

OIL FUNNEL CAP – OIL DIPSTICK

The mower is supplied without oil in the engine.

WARNING: Be careful not to overfill the engine with oil,

failing which the absorber would smoke when starting.

1. Make sure the mower stands on a flat surface.

2. Take out the oil tank cover.

3. Insert the oil dipstick and fix it.

IMPORTANT:

• The oil level needs to be checked before each use. If

necessary, add oil to the marking on the oil dipstick.

• The oil must be changed after 25 hours of operation or

each season. At works in a dusty or polluted environment

the oil may need to be changed more often. See “ OIL

CHANGE ” in the Maintenance article in these operating

instructions (SAE 30).

FUEL ADDING (unleaded petrol)

• The fuel is added through the filling hole in the tank.

Pay attention not to spill the petrol. Use common

clean unleaded petrol. Do not mix the petrol with oil.

Always buy only reasonable volume of petrol so that

you could consume it within 30 days.

WARNING: Wipe any spilled oil or petrol. Do not

store, pour, use near open fire.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gude BLACKLINE BL 560 E 95305 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info