Bedienungsanleitung Gude V 520 85071 (Seite 11 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Schwedisch, Norwegisch)

628830

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

• A maximum recharge time of 10 hours should

not be exceeded.

• Check the battery if charging an empty battery is

completed in just 1 minute. The battery could be

significantly discharged, which means it cannot be

charged any more with this charger.

Start-up Assistance

for vehicles with 35-105 AH lead-acid batteries 12V

• Battery charger, as in the manual of the connected

vehicle.

• Battery charger connected to the power supply, switching

and charging choose (12 V/24 V).

• Compress the „Boost“ button and wait for the time on the

timers displayed to expire in ca 2 min.)

• When the time of the times expire, a sign of AUU will

appear on the display, and the LED to assist at starting

will light up .

• The charger is for the startup process ready.

• On principle, two persons should always start up a

vehicle with chargers.

• The first person shall push the Start button on the charger

The other one shall immediately start the ignition, max. 9-

10 sec.

• As the vehicle starts up, stop starting immediately

• If the attempt to start fails, wait about 5 minutes for the

charger to get cooled and only then begin another

attempt to start.

Caution: The V520 battery charger e has a safety device

fitted to protect the instrument board electronics in the vehicle !

Æ Should the starting assistance be not in operation for the

first time, the battery has to be pre-charged unplugged for ca

20 minutes! (charging current of ca 20% of the battery

capacity)

Tip: If you change the battery for 10-15 minutes to

subpoena requires much less battery power startup.

Warning: The fuses may burn through and the

vehicle damaged if the starting time is more than 10 s.

Note: The terminals may not touch.

Notice: The charger is equipped with overload

protection.

Operator Safety Instructions

• Any safety and protection devices must be fitted in place

before switching the unit on.

• It is forbidden to attempt starting vehicles, the batteries of

which are discharged or damaged as that would result in

damaging the unit.

• Any attempts to start in position “charging” instead of

“starting” could damage the ammeter and start the

overload protection.

• Before pressing the main switch, make sure that the unit is

connected correctly.

• Warning! If in doubt, consult a specialist in an authorized

servicing center.

• Do not use the unit until you have read the manual

carefully.

• Observe all the safety regulation in this manual.

• Be responsible to the others.

Step-by-step Instruction

Charging

1. Connect the charger .

2. Plug in .

3. Switch the charger on 12V / 24 V

4. Select the charging current

Starting

1. Connect the charger .

2. Connect to the mains ě.

3. Switch the charger on 12 V/ 24V

4. Press “Boost“

5. Wait until “AUU“ is displayed

6. Start the vehicle

7. Stop immediately the starting process and switch off and

disconnect the charger as soon as the engine starts.

Troubles-Causes-Troubleshooting

Overload circuit-breaker:

1. Connect the red clamp to the positive pole and the black

one to the negative pole.

2. Remove the contact and check the fuses.

3. Set the charger at the lowest charging degree. .

Overload Causes

1. Mixing up the poles when connecting the clamp to the

battery

2. The battery is heavily or completely discharged.

3. Battery is completely discharged and its capacity is higher

than the charger power

4. Battery is damaged or defective (internal elements short

circuit).

Inspections and Maintenance

• Unplug before any work on the unit.

• Use a wet cloth to clean the plastic parts. Do not use

detergents, solvents and sharp articles.

• Use a soft brush or a paint brush to remove the settled

dust from the vent and moving parts.

Inspections and Maintenance Safety Instructions

After every use

Clean the vents and moving parts from dust

Regularly

Check all the screws to see if they are tight.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gude V 520 85071 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info