Helpline 00800 31133113
13
GB User ManualD BedienungsanleitungI Istruzioni per l’usoF Mode d’emploiNL Gebruiksaanwijzing
tions must be completed within 5 seconds after the previous step.
Otherwise, the remote control returns to standard operating mode. This
rule ensures that your remote control is not inadvertently reprogrammed by
another user.
Quick setup
Step 1 Insert the batteries (correct position is indicated at the base of the
battery slot).
Step 2 Select the device that you wish to control with your easytip by
turning the disk until the arrow points to the desired device, (e.g.
TV). (only for M2
TV/VCR
, M2
TV/SAT
, M2
TV/DVD
and M5)
Step 3 Switch on your device (to programme the remote control for the
TV set, ensure that the television shows a picture).
Step 4 Press the key and keep it pressed until the LED flashes twice
in quick succession. (after approx. 2 seconds).
Step 5 Within 5 seconds of seeing the 2 flashes above, enter the 4 digit
code indicated for your device in the separate code list book.
Step 6 After you have entered the code the LED will flash twice, indica-
ting that the code has been accepted by your easytip. This does
not necessarily mean it is the correct code for your model of
device.
Step 7 Press the key to check whether your easytip is working pro-
perly. If your device is thereby set to standby mode, check all
other functions of the remote control. If certain functions are not
available or not working properly, refer to the next code in the
list and repeat the programming procedure from step 3.
Step 8 Please keep this booklet in a safe place for future use!
Tips If your device does not respond to any of the code numbers:
Q. None of the code numbers worked?
A. This might be because more than 5 seconds lapsed before you entered
the code or because you input an invalid code number In this case,
check that you have entered the correct 4-digit code or repeat the pro-
gramming procedure with the next code in the list whilst observing the
5 second programming rule.
Q. My brand of TV is not listed in the code book?
A. Do not worry, simply read the section entitle “Automatic code scan”.
User Manual
