5
• T
a firm footing while spreading your w
• Opera
tired, ill, or under the influence of alcohol, drugs or medica
• Only ever use this trimmer in da
artificial light.
• Ensure the power switch is turned off before removing jammed ma
• Carry the Hammersmith Bionic T
spinning head sta
• Only switch on the motor once hands and feet are a
cutting area.
• Always ensure tha
• Before using the device, make sure tha
assembled.
• The appliance is only to be used for its intended purpose.
• Do not allow children or inexperienced users to operate the appliance.
• This appliance may be used by children abo
by persons of reduced ph
persons with insufficient experience or knowledge, provided they
are supervised or hav
appliance and understand the associa
• Extreme caution is advised when using the device near children and when
lea
• Always keep the handle dry
• Keep all bystanders, children and pets a
• Only use the supplied power adapter
• Do not use the device near flammable liquids, gases
potentially explosive environments
• T
earthed surfaces such as pipes, radia
• Never use the pow
• Never expose the device to rain or moisture, in order to reduce the
risk of electric shock.
• This product is designed for light grass trimming
this device is not intended for commercial or industrial use.
• Do not use the device if the power switch is defectiv
• T
is disconnected from the mains before making adjustments, or
changing or storing accessories.
• The appliance can pose danger in the hands of untrained users.
When not in use, keep the device out of reach of children and do
not allow it to be opera
these instructions).
• T
spinning parts, parts breakage, and any other conditions that could
affect its opera
• Keep the appliance clean. Use the device and accessories according
to these instructions. Using the unit for w
intended may result in injury
• Retain all warnings and instructions for future reference.
SAFETY INSTRUCTIONS FOR BATTERIES
BATTERY
• Protect the charger from rain and moisture to reduce the risk of
electric shock.
• Only ever charge the ba
• The supplied charger is only to be used for charging the
Hammersmith Bionic T
it must never be used to charge another device.
• Before each use, check the charger
If the charger is damaged, cease use, and do not a
• T
surfaces (such as paper
• If the appliance is dropped or subjected to a severe impact, liquid
may leak from the ba
contact with your skin, rinse the area immedia
may cause irrita
with your ey
• Do not open the ba
• T
as, for example, continuous exposure to sunlight or fire.
• T
• If the ba
it. If this happens, retrea
brea
Always wear protectiv
long sleeves, goggles and facial protection. Pay attention to
people, pets and children. Stop the device when people are
in the vicinity
should be cleaned of dirt after each use. Use only in a dr
environment. Do not use on wet grass. Use only as instructed.
BEFORE USE + ASSEMBL
UNPACKING
Assembly is required for this product.
1. Carefully remove the product and accessories from the box. Make sure tha
parts are included: Hammersmith Bionic T
24 cable ties, Protectiv
Operating instructions
2. Carefully inspect the product to ensure that no breakages or damage ha
occurred during transport.
WARNING: If any parts are damaged or missing, do not use this product until these
parts have been replaced. Failure to observe this warning can result in serious injury.
ASSEMBL
ASSEMBLING THE HANDLE WITH TELESCOPIC POLE
The telescopic pole (L) is designed for use with the Hammersmith Bionic T
close to the ground. Do not use this for hedge trimming
Mounting/adjusting telescopic pole (L):
a. Loosen the screw cap (M) on the pole, and pull out the telescopic pole until the desired
length is reached. T
b. Insert the end of the telescopic pole into the securing bolt, along with the rails.
Tighten the screw firmly
c. Y
d. T
TIP:
If you are unable to correctly insert the telescopic pole into the trimmer head,
check that the safety la
blocking the pole (see Figure B). T
reinsert the telescopic pole.
ASSEMBL
PROTECTIVE CAP G
1. Align the tabs with the notches on the main body
protective cap (G) can only be installed in one direction.
2. Using the supplied screw (K), secure the shield. Tighten the screw (K) on the
left side of the appliance.
FITTING AND REPLACING THE CABLE TIES
Ensure that the appliance is switched off before fitting or replacing the
cable ties (C).
1. Insert the cable tie (C) through the cable tie holder (H) as shown.
2. Thread the end of the cable tie (C) into the cable tie closure. Tighten it firmly
3. When replacing cable ties (C), cut off worn or damaged cable ties and replace
with new ones.
Follow these steps to fit new cable ties.
Important information about using other cable ties:
Yup to a thickness of 4mm
and a length of 98mm. If you only ha
shortened to the appropriate length of 98 mm after installation.
Warning: If the cable ties are not correctly shortened, they will come into contact
with the protective co
This affects the functioning of the device and its performance.
CHARGING FIG. 5
IMPORT
1. Charge the device using the supplied adapter
from red to green once the battery is fully charged.
It takes around 4 hours for the battery to fully charge.
FIRST USE: Y
All subsequent charges require a full 4 hours. Battery level indicator: The LED
indicator flashes RED when there is a low battery. The trimmer has 3-8 minutes
of operation left. Please fully charge the battery for optimal performance.
M21004_M20994_HammersmithBionicTrimmer_Manual_A4_20200227_CP.indd 5 27.02.20 08:24
