Bedienungsanleitung Harman Kardon AVR160 (Seite 15 von 48) (Englisch)

502590

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

ENGLISH

CONNECTIONS

There are different types of audio and video connections used to connect

the receiver, the speakers, the video display, and the source devices. The

Consumer Electronics Association has established the CEA® color-coding

standard. Some of these connectors are not used on the AVR 160, although

they may be found on other components in your system. See Table 1.

Table 1 – Connection Color Guide

Audio Connections

Front (FL/FR)

Left

White

Right

Red

Center (C) Green

Surround (SL/SR) Blue Gray

Surround Back (SBL/SBR) Brown Tan

Subwoofer (SUB) Purple

Digital Audio Connections

Coaxial Orange

Optical

Input

Output

Video Connections

Component Y Green Pb Blue Pr Red

Composite Yellow

HDMI™ Connections

(digital audio/video)

HDMI

Figure 1

Speaker Connections

Speaker cables carry an amplified signal from the receiver’s speaker terminals

to each loudspeaker. They contain two wire conductors, or leads, inside plastic

insulation, that are differentiated in some way, such as with colors or stripes.

The differentiation preserves polarity, without which low-frequency

performance can suffer. Each speaker is connected to the receiver’s speaker-

output terminals using two wires, one positive (+) and one negative (–).

Always connect the positive terminal on the speaker, which is usually colored

red, to the positive terminal on the receiver, which is colored as indicated in

the Connection Color Guide above (Table 1). The negative terminals are both

black

Bare wire cables are installed as follows (see Figure 2):

Unscrew the terminal cap until the pass-through hole is revealed.1.

Insert the bare end of the wire into the hole.2.

Hand-tighten the cap until the wire is held snugly.3.

Figure 2 – Binding-Post Speaker Terminals With Bare Wires

Subwoofer

The subwoofer is dedicated to the low frequencies (bass), which require

more power. To obtain the best results, most speaker manufacturers offer

powered subwoofers that contain their own amplifier. Usually, a line-level

(nonamplified) connection is made from the receiver’s Subwoofer Output to a

corresponding jack on the subwoofer, as shown in Figure 3.

Although the purple subwoofer outputs look similar to full-range analog

audio jacks, they are filtered to allow only the low frequencies to pass. Don’t

connect these outputs to any other devices.

Preout Subwoofer

Figure 3 – Subwoofer

CONNECTING SOURCE DEVICES

TO THE AVR

Audio and video signals originate in “source devices,” including your Blu-ray

Disc or DVD player, CD player, DVR (digital video recorder) or other recorder,

tape deck, game console, cable or satellite television box, MP3 player, USB

drive or network device. The AVR’s tuner also counts as a source, even though

no external connections are needed, other than the FM and AM antennas.

Separate connections are required for the audio and video portions of the

signal, except for digital HDMI connections. The types of connections used

depend upon the capabilities of the source device and video display.

Audio Connections

There are two types of audio connections: digital and analog. Digital audio

signals are required for listening to sources encoded with digital surround

modes, such as Dolby Digital and DTS, or for noncompressed PCM digital

audio. There are three types of digital audio connections: HDMI, coaxial and

optical. Do not use more than one type of digital audio connection for each

source device. However, it’s okay to make both analog and digital audio

connections to the same source.

NOTE

: HDMI signals may carry both audio and video. If your video display

device has an HDMI input, make a single HDMI connection from each

source device to the AVR. Usually, a separate digital audio connection is not

required. Turn the volume on your television all the way down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon AVR160 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon AVR160

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info