Bedienungsanleitung Harman Kardon HK3390 (Seite 9 von 28) (Englisch)

502537

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

REAR-PANEL CONNECTIONS

AM and FM Antenna Terminals: Connect the included AM and

FM antennas to their respective terminals for radio reception.

Video 1, Video 2 and Video 3 Audio/Video Inputs: These

jacks may be used to connect your video-capable source components

(e.g., VCR, DVD player, cable TV box) to the receiver.

NOTE: The Video 3 source has inputs on both the front and

rear panels of the HK 3390, and you may connect different

devices to each set of inputs. To select between the two sets of

inputs, press the Video 3 Source Selector repeatedly.

Video 1 Audio/Video Outputs: These jacks may be used to

connect your VCR or another recorder.

Video Monitor Output: If some of your sources use video

connections, connect the Video Monitor Output to the corresponding

input on your television or video display. No video signal will be available

with an audio-only source, such as CD or Tape.

Remote Infrared (IR) Input and Output: When the remote

IR receiver on the front panel is blocked, such as when the HK 3390

is placed inside a cabinet, connect an optional IR receiver to the

Remote IR Input jack. The Remote IR Output may be connected to the

Remote IR Input of a compatible source device (or other product) to

enable remote control through the HK 3390. When several devices

are used, connect them in “daisy chain” fashion.

AC Power Cord: After you have made all other connections, plug

the AC power cord into an unswitched outlet.

Switched AC Accessory Outlets: You may plug the AC power

cord of one source device into each of these outlets, and it will turn on

whenever you turn on the receiver. Do not use sources that consume

more than 100 watts of power per outlet.

Speaker 1 and 2 Outputs: Use two-conductor speaker wire to

connect each set of terminals to the correct speaker. Observe the

correct polarity (positive and negative connections). Use the Speaker

1/2 Selectors on the front panel or remote to select either or both pairs

of speakers for playback.

Subwoofer Outputs: If you have a powered subwoofer, connect

these jacks to the line-level inputs on the subwoofer. The same full-

range signal is output through both jacks. Thus, you have the option of

connecting each jack to the line-level input on a separate subwoofer, or

to use these full-range outputs to feed a remote room in a distributed-

audio application. If you have only one subwoofer with a single line-level

input, connect it to the right Subwoofer Output on the HK 3390.

Subwoofer Trigger Outputs: Connect these outputs to a

compatible trigger input on the subwoofer connected to the Subwoofer

Output immediately to the right of the Trigger Output. Consult the

owner’s manual for the subwoofer to set its trigger input correctly,

and the subwoofer will automatically turn on or off when the HK 3390

is turned on or off. In addition, the Trigger Outputs are used with the

Subwoofer Link Switches to conserve energy by powering off the

subwoofer’s amplifier when it is not needed. The Subwoofer Trigger

Outputs send a signal of 15 volts DC.

Subwoofer Link Switches: Each switch affects the subwoofer

connected to the jack immediately to the left of the switch. To use

the switch, first connect the corresponding Subwoofer Trigger Output

to a compatible trigger input on the subwoofer, and make sure the

subwoofer’s instructions are followed to activate its trigger input. When

the Link Switch is on, the HK 3390 will remove the trigger signal

whenever the corresponding pair of main speakers are not in use,

thereby conserving energy that would otherwise be used to maintain

the subwoofer’s amplifier in standby mode. This feature is activated

any time no signal is present at the main speaker outputs, including

when the Speaker 1/2 Switch turns off both speaker pairs, when the

HK 3390’s output is muted, or when the headphones are plugged in.

See Table A2 in the appendix for details.

Main-Amp Inputs and Preamp Outputs: These jacks are

normally connected directly to each other with an included jumper.

Some devices, such as equalizers and some loudspeaker systems,

require connection between the Preamp Outputs and Main-Amp Inputs,

in which case the jumpers should be removed and stored in a safe

place for future use. You may also connect the Preamp Outputs to an

external amplifier, or connect another device for a special application.

Tape Outputs: These jacks may be used to connect your CDR or

another audio-only recorder.

CD and Tape Inputs: These jacks may be used to connect your

audio-only source components (e.g., CD player, tape deck). Do

not connect a turntable to these jacks unless you are using the turntable

with a phono preamp. When your recorder features three-head or

off-head playback, you may monitor a recording as it is being made.

Phono Inputs and Ground: Connect the outputs of your turntable

or tonearm to these jacks, and connect the ground wire from the

turntable to this Ground Connector to reduce system hum. Only moving-

magnet (MM-type) cartridges are compatible with the Phono Inputs. If

your turntable is equipped with its own onboard phono preamp, you

may connect it to any of the HK 3390’s other audio inputs.

Main Power Switch: This mechanical switch turns the power supply

on or off. It is usually left turned on (push the rocker in at the top), and

cannot be turned on using the remote control. Turn this switch off when

connecting or disconnecting source devices or loudspeakers to prevent

any possibility of damage from an unexpected power surge.

Update Port: Do not make any connections to this port. It is reserved

for use by authorized service personnel in the event that a software

update becomes available.

Reset Button: If the HK 3390 behaves erratically, perform a system

reset by turning the unit off (the Power Indicator will turn amber) and

using a fine-point pen or similar object to press this button.

HK1695 3390OM 6/13/08 12:12 PM Page 9

Harman Kardon HK3390 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon HK3390

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info