Bedienungsanleitung Harman Kardon HKTS 5 (Seite 6 von 10) (Englisch)

534545

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

HKTS 5

Speaker Connections

IMPORTANT NOTE: Before making speaker connections, be certain that your receiver or

audio power ampliﬁer is turned off and preferably unplugged from its AC power source.

Do not connect the HKTS 160SUB subwoofer to an AC power source until you have made

all speaker-wire connections.

Speakers and other electronics have corresponding (+) and (–)

terminals. Most makers of electronics, including harman kardon

engineers, use red to denote the (+) terminal and black for the

(–) terminal.

Newer harman kardon receivers conform to the CEA standard and

therefore use a color other than red or black for the (+) terminal to indicate some speaker

positions: e.g., surround left.

Although the HKTS 5 system has red and black collars on the individual speaker terminals

to denote the positive and negative connections, your system includes a colored band on

the positive lead at both ends of every speaker cable and a matching colored sticker for

each of the four satellite speakers, conforming to the key on page 4. The center speaker

has a green (+) terminal, and the subwoofer has a purple SUB input jack. This system is

intended to help you ensure that the speaker in each location is connected to the correct

terminals on your receiver or ampliﬁer.

The (+) lead of the speaker wire is indicated with a stripe and has the colored band

corresponding to the speaker’s position. It is important to connect all speakers identically:

(+) on the speaker to (+) on the ampliﬁer and (–) on the speaker to (–) on the ampliﬁer.

With the advent of multichannel surround-sound systems, connecting all of the speakers

in your system with the correct polarity remains equally important in order to preserve

the proper ambience and directionality of the sound.

To connect the supplied speaker wires to the satellite and center speaker terminals

located on the bottom of each speaker, press the red or black tab, insert the bare end

of the wire into the hole, and release the tab. Gently tug on the wire to make sure that

it is fully inserted.

Speaker Connections

HKTS 160SUB

LEFT

SUB

LFE OUT

+– +–

+–

RIGHT

SURROUNDFRONT CENTER

Connecting the Subwoofer

Use the LFE (purple) connector to connect the HKTS 160SUB’s Line-Level LFE In

connector to the dedicated subwoofer output (or LFE output) of your receiver or preamp/

processor. If the receiver or preamp/processor has a low-pass ﬁlter on the subwoofer

output, set the subwoofer's Crossover Control to maximum (150 Hz).

Connect each satellite speaker and the center speaker to the corresponding speaker

terminals on your receiver or ampliﬁer.

In your receiver or preamp/processor’s setup menu, conﬁgure the receiver or preamp/

processor for “Subwoofer ON,” and set the front, center and surround speakers to

“Small.” After you have made and veriﬁed all connections, plug the HKTS 160SUB’s AC

Power cord into an active AC outlet.

Front Left Speaker Cable

(White Bands)

Center Speaker Cable

(Green Bands)

Front Right Speaker Cable

(Red Bands)

LFE Cable

(Purple Ends)

Surround Right Speaker Cable

(Gray Bands)

Surround Left Speaker Cable

(Blue Bands)

Receiver

Subwoofer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon HKTS 5 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Harman Kardon HKTS 5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info