801892
24
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 7 of 16 AquaRite® Pro LS Rev. D
SETTINGS: Push the SETTINGS button to enter the Settings Menu.
CURSORS (+, -, <, >): Use these buttons to scroll through submenus, make selections and adjust values.
Indicator LED's
RUN/STOP: When illuminated, the AquaRite Pro LS is in automatic mode and will produce chlorine based on the
desired output % or ORP setting (when AQL-CHEM is used). When the LED is off, the AquaRite Pro LS has been
manually turned off. It will not produce chlorine until RUN has been selected.
SUPER CHLORINATE: When illuminated, the Super Chlorinate feature is active.
CHECK SYSTEM: When Check System is illuminated, an error has occurred that requires attention. Refer to the
Troubleshooting section of this manual for possible errors and solutions.
Information Menu
The Information Menu displays valuable system and pool information. The AquaRite Pro LS will default to displaying
a portion of the Information Menu when no buttons have been pushed for 2 minutes. The unit will automatically scroll
through several status displays. To access all of the Information Menu items, push the INFO button on the front panel.
Advance through the various menu items using the "<" or ">" buttons. A list of the Information Menu items is shown below.
If ORP Auto Sensing is not used
Chlorinator
50 %
No Function
Move to previous/next menu item
Super Chlorinate
22:15 remaining
No Function
Move to previous/next menu item
The AquaRite Pro LS desired output % is shown here. If Super Chlorinate is active, the display will show
the time remaining until the AquaRite Pro LS will return to the desired output %. This menu is disabled if
an AQL-CHEM is used and ORP Auto Sensing is enabled (see AQL-CHEM manual).
If AQL-CHEM is used
No Function
Move to previous/next menu item
pH 7.5 (On)
ORP 700 mV (On)
This display will be shown only if chemical sensing is enabled. This display shows both pH and ORP
levels/status when chemistry sensing is enabled via the Chemistry Configuration Wizard (requires the
use of AQL-CHEM Sensing Kit). The AquaRite Pro LS will refer to these levels to determine how much
chlorine to generate (ORP) and how much acid to dispense (pH). Refer to the AQL-CHEM manual for
specific information about these levels as well as the recommended ranges.
Press to switch chlorinator operation to opposite polarity (15 second delay)
Move to previous/next menu item
+23.45 +6.75A
29°C 1.5 g/L
+/- 23.45V is the voltage applied to the chlorinator cell
+/-6.75A is the current (amps) through the cell
29°C is the water temperature at the cell
1.5 g/L is the “instant” salt level at this time
For the chlorinator to be operating, several conditions must exist: the filter pump must be running,
the flow switch must be detecting flow, the chlorinator setting must be set greater than 0%, the water
temperature at the cell must be between 12ºC and 60ºC, and the salt level must be within the operating
range. If any of these conditions are not met, the chlorinator diagnostic display will tell you the reason.
It’s possible to have more than one reason, in which case after you rectify what was displayed the first
time, a second display will appear.
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hayward Aqua Rite Pro LS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info