801911
30
Zoom out
Zoom in
Vorherige Seite
1/177
Nächste Seite
6 / 20 AquaRite Pro Rev. C
Controls
Keypad Buttons
RUN/STOP: The AquaRite Pro will toggle back and forth between RUN and STOP
with each push of the RUN/STOP button.
RUN: When in RUN mode, the AquaRite Pro will produce chlorine according to the

pumping cycle. The AquaRite Pro can only produce chlorine when RUN is selected

STOP: When in STOP mode, the AquaRite Pro is prevented from energizing the elec-
trolytic cell. In this position there is no chlorine generation. NOTE: To service any
of the pool equipment or the AquaRite Pro, the power must be turned off at the circuit
breaker.
SUPER CHLORINATE: (if optional AQL-CHEM sensing is NOT used) When you
have an abnormally high bather load, a large amount of rain, a cloudy water condition,

SUPER CHLORINATE should be selected. This electronically “super chlorinates”


AquaRite Pro will automatically revert back to the previous desired output % setting
at the end of the super chlorinate period.
INFO: Push the INFO button to enter the Information Menu (see Information Menu
page 7).
SETTINGS: Push the SETTINGS button to enter the Settings Menu (see Settings
Menu page 9).
CURSORS (+, -, <, >): Use these buttons to scroll through submenus, make selections
and adjust values.
Indicator LED's
RUN/STOP: When illuminated, the AquaRite Pro is in automatic mode and will
produce chlorine based on the desired output % or ORP setting (when AQL-CHEM is
used). When the LED is off, the AquaRite Pro has been manually turned off. It will
not produce chlorine until RUN has been selected.
SUPER CHLORINATE: When illuminated, the Super Chlorinate feature is active.
CHECK SYSTEM: When Check System is illuminated, an error has occurred that
requires attention. Refer to the Troubleshooting section of this manual for possible
errors and solutions.
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hayward Aqua Rite Pro wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info