Bedienungsanleitung Hayward Aqua Rite Pro (Seite 32 von 177) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

801911

Zoom out

Zoom in

Vorherige Seite

1/177

Nächste Seite

8 / 20 AquaRite Pro Rev. C

The AquaRite Pro periodically reverses the polarity of the voltage applied

to the cell in order to automatically clean off any calcium deposits that may

have built up on the cell. It is important that you check the chlorinator

operation in both polarities. To do this, press either the “+” or “-“ buttons

and the chlorinator will turn off, wait for 15 seconds and then turn on in the

opposite polarity.

This is the average "Salt Level" in the pool. This value is calculated over time

and minimizes the effects of spikes or dips that may naturally occur.

The “Instant Salt” is calculated based on the voltage, current (amps), and

water temperature at the cell at that instant. There are a number of reasons

why instant and average salt readings may differ. Some of these include salt

having just been added to the pool and not yet thoroughly mixed, calcium

buildup on the cell, and cell aging.

Press the "+" button to enter the instant salt value into the average salt level.

The average salt level will use this new value for its calculations.







Available displays depend on conguration. These displays show the software

revisions of various components.

For optimum operation, you will need to inspect the AquaRite Pro chlorinator

cell approximately every 3 months and clean the cell if necessary. The

AquaRite Pro will automatically remind you and display “Inspect Cell, hold

+ to reset” as part of the rotating Information Menu. Clean the cell and then

press the “+” button during the “Inspect Cell” display to reset the timer.

Salt Level

3.2 g/L

No Function