Bedienungsanleitung Hendi 226001 (Seite 7 von 128) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

741700

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

• Before checking gas leakage, make sure any

switches on the appliance are set to “off” position

and gas supply is on. To check the gas leakage,

cover the connector of the hose with soap foam.

If there is gas leakage, bubbles will occur. Check

gas leakage again.

• While checking gas leakage, never use ﬁ re.

• Especially if operated with LPG, make sure the re-

lief valve complies with appliance requirements.

• Caution: The operating gas pressure in the ap-

pliance is max. 50 mbar. Gas leakage is likely if

gas pressure exceeds 50 mbar.

• The appliance is equipped with a LPG controlling

device set to 50 mbar. The LPG pipe must be ﬁ t-

ted with “level 1” adjuster device designed for

higher pressure.

• Defective parts may only be replaced by original

spare parts. The manufacturer shall be liable for

safety of operation only if such parts are used.

• The manufacturer shall not be liable for any

damage that may be caused by improper mount-

ing or connection of the appliance.

4.4 RULES OF OPERATION

• Please read carefully the Instruction Manual be-

fore ﬁ rst operation. This will make it possible to

protect the operator and prevent the appliance

from being damaged.

• Use the appliance only when assembled. This

will avoid possible contact with conductive parts

of the appliance.

• Use the appliance only on a ﬂ at surface.

• Use the appliance only for grilling Doner kebab

meat. The manufacturer shall not be liable for

any damage arising from use of the appliance for

any other purpose.

4.5 PROTECTING APPLIANCE AGAINST DAMAGE

While installing the appliance, be careful not to hit

the ON/OFF knob of the heater mechanism (2) or

the motor body (4).

Caution: There is a risk of burning due to hot sur-

faces of the fixed frame, skewer, upper-skewer

locking mechanism and motor guide rail. Clean

the surfaces once cooled.

Prevent any metal and similar parts entering into

the ventilation openings on the appliance body as

they may damage gas ﬁ ttings and electrical parts.

Caution: The operating gas pressure in the appli-

ance is max. 50 mbar. Gas leakage is likely if gas

pressure exceeds 50 mbar.

Immediately clean any dirt that may occur on the

surfaces of the appliance to prevent them from

burning and sticking on the surface.

Never use water and steam under pressure as

cleaning tools. Such cleaning tools may damage

the appliance.

When transporting the appliance, wrap it up with

foil for protection against dust.

4.6 PROTECTION AGAINST BURNS

• The ﬁ xed frame and the adjoining areas become

hot during use and remain so for a certain time

after switching off. Consequently, the place for

using the appliance should not be accessible to

customers and children, except for the user.

• Burning risk! While using your appliance, protect

your hands with heat-resistant gloves. Addition-

ally, make sure that they are not wet or damp,

as dampness and wetness increase thermal con-

ductivity of the gloves. Your hands may burn.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 226001 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info