Bedienungsanleitung Hercules BOSCH Purion Pedelec Display 2020 (Seite 59 von 117) (Englisch)

761549

Zoom out

Zoom in

Vorherige Seite

1/117

Nächste Seite

Operation

The ideal setting in relation to the weight of the

rider has been achieved when the shock

absorber deflects 3 mm under the stationary

load of the rider. Reattach the cover after the

adjustment.

6.3.5.4 Adjusting the rebound

Only applies to pedelecs with this equipment

The rebound defines the speed at which the fork

rebounds after being loaded. The rebound setting

depends on the air pressure setting. Higher sag

settings require lower rebound settings.

Turn the rebound adjuster clockwise to the

closed position until it stops.

Figure 59: Suntour rebound adjuster (2) on the fork (1)

Turn the rebound adjuster anti-clockwise.

Adjust the rebound in such a way that the fork

rebounds quickly, but without bottoming out

upward during testing. Bottoming out is where

the fork rebounds too quickly and stops moving

abruptly once it has reached the full rebound

distance. You will hear and feel a slight knock

when this occurs.

6.3.6 Adjusting the suspension of the

FOX fork

Only applies to pedelecs with this equipment

! CAUTION

Crash caused by incorrectly set suspension

If the suspension is adjusted incorrectly, the fork

may become damaged, so that problems may occur

when steering. This will cause a crash with injuries.

Never ride the pedelec without air in the air

suspension fork.

Never use the pedelec without adjusting the

suspension fork to the rider's weight.

Notice

Settings on the chassis change riding

performance significantly. You need to get used

to the pedelec and break it in to prevent

accidents.

The adjustment shown here represents a basic

setting. The rider should change the basic setting

to suit the surface and his/her preferences.

It is advisable to make a note of the basic

setting. This way, it can be used as the starting

point for subsequent, optimised settings and to

safeguard against unintentional changes.

6.3.6.1 Adjusting the negative deflection

Negative deflection (sag) is compression of the

fork caused by the weight of the rider and their

gear (e.g. a backpack), the sitting position and the

frame geometry. This sag is not caused by riding.

Each rider has a different weight and sitting

position. The sag depends on the rider's position

and weight and should be between 15% and 20%

of the maximum fork deflection, depending on

pedelec usage and preferences.

When adjusting the sag, ensure that each

compression adjuster is in the open position, i.e.

turned clockwise until it stops.

The pressure is to be measured at an ambient

temperature of 21 to 24 °C.

The air valve is located under a blue cover on

the head of the left shock absorber. Screw off

the cover anti-clockwise.

Place a high-pressure pump on the valve.

MY20H01-42_1.0_21.06.2019 58

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hercules BOSCH Purion Pedelec Display 2020 Seite 59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hercules BOSCH Purion Pedelec Display 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info