Bedienungsanleitung Hifonics txi 1700 (Seite 14 von 20) (Deutsch, Englisch)

168839

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Speaker & RCA Connections

TXi 1700

LOW PASS-MODE / Subwoofer operation with lowpass

• Connect the "LINE IN" of the amplifier to the head unit´s line output with appropriate good quality RCA cables.

• Connect the subwoofer with appropriate wires to the terminal block (SPEAKER OUTPUT - and +) of the amplifier. As optional feature an

additonal subwoofer can be connected to the non-occupied terminals.

• The minimum final subwoofer impedance must not be lower than 1 Ohms in total. Too low speaker loads result in too high heat dissipation and

may cause the amplifier run into protection.

• Please observe correct speaker channels and polarity as printed by the speaker terminal.

PHASE - Control

• This controller allows to adjust the Phase Shift 0° to 180°, to match the subwoofer to the vehicle's acoustic enviroment.

FREQ RANGE - Control

• Allows you to adjust the frequency at which the bass boost should work. It is continously variable between 20Hz up to 80Hz.

Q - Control

• Allows you to adjust the filter performance Q of the crossover. So you can change the playback quality in the range of the cut-off frequency.

"WIDE" Q - 0.3, "NARROW" Q - 1.0. Regular setting is on 12 o`clock - position Q - 0.5/Linkwitz-Reilly an 3 o`clock - position Q - 0.7 /Butterworth.

SUB BOOST - Control

• This controller regulates the Bass Boost from 0 - 18 dB.

Caution! Please use the Bass-EQ carefully. The additional boost may result in clipping or overload.

BASS REMOTE

• The provided Bass Remote regulates the Bass Level from e.g. the driver's seat.

MODE - Switch

• Set the switch in this operation mode to "LP" - position.

SUB SONIC - Control

• This eliminates the lowest frequencies and protects the speakers from damage. Set the frequency between 15Hz-55Hz, depending on the size of

the installed subwoofer.

NOTE: If the SUBSONIC - Level is higher than the LOW PASS - Level, no sound is hearable.

LOW PASS - Control

• This eliminates the higher frequencies. Set the crossover-frequency between 35Hz-250Hz, depending on the size of the installed subwoofer.

LEVEL - Control

• Turn the LEVEL control of the amplifier to 6V position.

• Turn the head unit volume control to about 80 - 90% of its full setting.

• Turn the LEVEL control clockwise until you hear some distortion.

• Then turn back the LEVEL control slightly until you can hear a clean sound.

•

Bass Remote Control - connection for remote control.

This contoller regulates the bass level from e.g. the driver's seat.

By using a additional subwoofer,

connect it to the non-occupied

terminals, ensure that the total

impedance load is not lower

than 1 Ohm.

Caution!

Do not connect speaker (-) to the ground or vehicle's chassis.

Subwoofer

1 - 8 Ohm

0dB 18dB

Connect RCA outputs (CH1/2 or SUB OUT) of the

head unit with LINE INPUT of the amplifier.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hifonics txi 1700 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info