168668
18
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
5-CHANNEL AMPLIFIER: ZXi8805
18
FUNCTIONS AND OPERATIONAL CONTROLS
1
3
The REMOTE port is for the cable of the enclosed bass remote controller and only to use in the LP/BP mode. With this bass
remote controller, you are able to adjust the bass level e.g. from the driver’s seat. Please use only the enclosed bass remote
controller and cable.
1
4
The LOW PASS CH3/4 and CH5 controllers adjust the cut-off point of the frequency range to above for the regarding channel
pair. The cut-off frequency is continuously adjustable, on Channel 3/4 from 250 Hz to 4kHz and on Channel 5 from 30 Hz to
150 Hz.
5
The BASS BOOST CH5 controller adjust the bass boost enhancement continuously from 0dB to +10dB.
6
The HI PASS CH1/2 and CH3/4 controllers adjust the cut-off point of the frequency range to below for the regarding channel
pair (Channel 1/2 or Channel 3/4). The cut-off frequency is continuously adjustable, on Channel 1/2 from 50Hz to 4kHz, on
Channel 3/4 from 50Hz to 150Hz.
7
The LEVEL CH1/2, CH3/4 and CH5 controllers adjust the input sensitivity of the amplifier to align the audio signal of the head
unit for the regarding channel pair (Channel 1/2, Channel 3/4 or Channel 5). The input sensitivity is adjustable from 6 to 0.2
Volts.
8
POWER/PROTECT
If the POWER LED lights up, the amplifier is ready for operation.
If the PROTECT LED lights up, a malfunction is indicated. Attend in this case the chapter TROUBLE SHOOTING.
The LINE INPUT RCA jacks must be connected with the RCA output jacks of the headunit.
1
2
The CH1/2 and CH3/4 X-OVER switch selects the required operation mode of the amplifier on the regarding channel pair
(Channel 1/2 or Channel 3/4).
Position HP: Highpass mode (The higher frequencies will be eliminated. Adjustable by the highpass controller).
Position FULL: Fullrange mode (The whole frequencies will be amplified).
Position BP: The HI PASS controller works in this operation mode as subsonicfilter and eliminates the lower frequencies
(Bandpass-Mode).
9
The MODE switch must be in 2CH position, if you connect only one RCA stereo audio cable with the CH1/2 line inputs.
Select the position 4CH, if you connect two RCA stereo audio cables on the CH1/2 and CH3/4 line inputs. Select the position
5CH, if you connect three RCA stereo audio cables with the CH1/2, CH3/4 and CH5 line.
Do not connect loudspeaker cables with the vehicle’s chassis. Always ensure the correct polarity
of all connections. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
REFERENCE NOTE
1 42 5 6 7 8 93
CH 3
CH 4
LINE INPUT
CH 1
CH 2
CH 5
LEVEL HI PASS
6V 0.2V
50Hz
150Hz
BASS BOOST LEVEL
0dB 10dB 6V 0.2V
50Hz 4kHz
LOW PASS
30Hz 150Hz
X-OVER
CH 1/2
HP
FULL
REMOTE
HI PASS LOW PASS
HP FULL BP
X-OVER
CH 3/4
LEVEL
6V 0.2V250Hz 4kHz
CH 5
POWER
PROTECT
MODE
4 CH 5 CH2 CH
2 4 7
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hifonics zxi8805 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info