Bedienungsanleitung Hikoki RP350YBL (Seite 9 von 188) (Alle Sprachen)

816295

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

English

12.2 Reduction in suction power

If the suction power decreases, carry out the

following steps:

1. Clean the filter cassettes by activating the

electromagnetic vibrator (set switch (2) to the

"IR" position).

2. Empty the container or replace the fleece filter

bag (5) or PE disposal bag (sold separately).

3. Replace the filter cassettes (14).

12.3 Renew the filter cassettes (14)

Shake the filter cassettes (14) once again before

replacing the filters, by switching on the

electromagnetic vibrator (set switch (2) to the "IR"

position).

Use a coin or a similar object to turn the locking

knob (12) on the locking bar (11) counter-clockwise

through 90° and push the bar (11) to the rear. Swing

up the hood and pull up the filter cassettes (14) to

remove them. Seal the removed filter cassettes

immediately in a dust-tight plastic bag and dispose

of them in accordance with regulations. Insert new

filter cassettes, ensuring they are correctly and

securely in place.

12.4 Motor protection filter

Regularly check the motor protection filter. If the

motor protection filter (13) is contaminated, this

indicates that the filter cassettes (14) may be

defective:

- Replace the filter cassettes (14).

- Replace the motor protection filter (13), or rinse it

under running water, dry it and then replace.

12.5 Water sensor

IMPORTANT - Clean the water

sensor regularly and check it for

signs of damage.

If the volume flow control display (3) flashes, this

indicates that the fleece filter bag must be emptied.

Reduction in suction power:

See the instructions in the section on Cleaning.

• Filter cassettes (14) soiled? - clean.

• Fleece filter bag (5) full? - replace.

• PE disposal bag (sold separately) full? - replace.

• Container (9) full? - empty.

• Motor protection filter (13) clogged? - See

chapter 12.

• Nozzle, tubes or hose blocked?- clean.

Device will not start:

• Is the plug in the plug socket?

• No power from mains?

• Mains lead OK?

• Device hood correctly closed?

• Has the water sensor cut off? - Empty the

container; then switch on and off again.

• Switch (2) in "AR" position? - Set to "I" or "IR".

See chapter 9.1.

• The dust extractor is not switched on or off by

means of a power tool, even though switch (2) is

set to the "AR" position. - Connect the power tool

to the plug socket (4).

Dust in the container when fleece filter bag is

fitted:

• The position of the rotary slide is incorrect. See

chapter 8.1.

PE disposal bag is sucked to the filter

cassettes (14):

• The position of the rotary slide is incorrect. See

chapter 8.2.

Use only genuine HiKOKI accessories. See

page 182.

Use only accessories that fulfil the requirements

and specifications listed in these operating instruc-

tions.

Replacing supply cord

If the replacement of the supply cord is necessary,

it has to be done by HiKOKI Authorized Service

Center to avoid a safety hazard.

CAUTION! In the operation and maintenance

of power tools, the safety regulations and

standards prescribed in each country must be

observed.

13. Troubleshooting

14. Accessories

15. Repairs

RP350YBL_C99749971_305.book 9 ページ２０２３年４月６日　木曜日　午後１時６分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hikoki RP350YBL Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info