FRONTCONTROLPANEL
Access to the front control panel is gained by pushing the door in
and releasing. The front control panel contains items such as the
Headphone socket, Audio/Video sockets, Programme + /- and
Volume +/- buttons. Also located on the front are the ON/OFF
button, Infra Red Lens and TV Mode Light.
TV Controls Overview
TV Controls Overview
REAR CONNECTING SOCKETS
The rear of your TV contains an aerial RF input and two scart
sockets, AV1 and AV2. The RF/ aerial socket is
permanently connected to an RF source i.e. an aerial antenna
shown in TV Installation section . The scart sockets are used to
connect external equipment such as VCR s, Satellite Receivers /
Decoder etc. Connection of this equipment is explained in greater
detail in the Connecting of External AV Equipment section of
this manual. Also located on the rear of the TV are the Audio
Sockets and the *18 Volt Output socket.
Consult your HITACHI dealer with regards to purchasing
HITACHI auxiliary equipment.
SWITCHING ON
To switch your TV on, press the ON/OFF button shown above. If the TV fails to display anything on the screen, but the red TV mode light
appears bright, then the TV is in Stand by mode. Press the Stand by button on your handset to
activate the TV. The red TV mode light will then dim and you should allow the TV a few seconds for a picture to appear.
6
6
* IF FITTED
**
*IMPORTANT NOTE The 18 Volt Output socket is used for connection of HITACHI
auxiliary equipment only and under no circumstances should be connected to other
external equipment. Failure to observe this may result in serious damage to your equipment.
*
** IF FITTED
