386263

Hitachi ds 12dvf2 Seite 31

31
Zoom out
Zoom in
Vorherige Seite
1/41
Nächste Seite
30
English
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latche
(1 pc or 2 pcs.) to remove the battery. (see Figs.
1 and 2)
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its direction. (see
Fig. 2)
CHARGING
Before using the driver drill, charge the battery as
follows.
<UC9SD•UC12SD•UC14SD>
1. Insert the battery into the charger.
Insert the battery firmly while observing its direction,
until it contacts the bottom of the charger. (See
Figs. 1 and 3)
CAUTION:
⅜ The UC9SD, UC12SD and UC14SD models are
the exclusively designed chargers. These cannot
charge batteries except the specified batteries.
It is possible to insert the batteries other than
the specified into the chargers and some of
them may light up the pilot lamps. However,
you are requested to exercise utmost caution
not to charge batteries other than specified ones
because these can not only be charged but also
such actions can result in the malfuntion of
chargers.
⅜ If the batteries are inserted in the reverse
direction, not only recharging will become
impossible, but it may also cause problems in
the charger such as a deformed recharging
terminal.
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION:
⅜ If the pilot lamp does not light up, pull out the
power cord from the AC outlet and check the
battery mounting condition.
3. Charging
About 60 minutes are required to fully charge the
battery at a temperature of about 20°C. The pilot
lamp goes off to indicate that the battery is fully
charged.
The temperatue for batteries (EB914, EB1214L,
EB1414) is 10 – 40°C, and batteries that have become
hot should be cooled for while before being
recharged.
NOTE:
The battery charging time becomes longer when
a temperature is low or the voltage of the power
source is too low.
When the pilot lamp does not go off even if more
than 120 minutes have elapsed after starting of the
charging, stop the charging and contact your
HITACHI authorized service center.
CAUTION:
If the battery is heated due to direct sunlight,
etc., just after operation, the charger pilot lamp
may not light up. At that time, cool the battery
first, then start charging.
4. Disconnect the charger’s power cord from the
receptacle.
5. Hold the charger firmly and pull out the battery.
NOTE:
After operation, pull out batteries from the charger
first, and then keep the batteries properly.
<UC14YFA>
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals.)
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Fig. 1 and 3)
CAUTION:
⅜ If the battery is inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as deformed charging terminals.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery is fully charged, the pilot lamp will
blink in red. (At 1-second intervals.) (See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
Table 1
Indications of the pilot lamp
Before Blinks Lights for 0.5 seconds. Does not light
charging (RED) for 0.5 seconds. (off for 0.5 seconds)
While Lights Lights continuously
charging (RED)
Charging Blinks Lights for 0.5 seconds. Does not light
completed (RED) for 0.5 seconds. (off for 0.5 seconds)
Charging Flickers Lights for 0.1 seconds, Does not light Malfunction in the battery or
impossible (RED) for 0.1 seconds. (off for 0.1 seconds) the charger
Charging Lights Lights continuously The battery temperature is high,
impossible (GREEN) making recharging impossible.
… 31 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hitachi ds 12dvf2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Hitachi ds 12dvf2

Hitachi ds 12dvf2 Bedienungsanleitung - Deutsch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch - 53 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info