Bedienungsanleitung Honda Honda Engines GC190 (Seite 5 von 44) (Englisch)

13057

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

ENGLISH

• Read the instructions before you begin, and make sure you have

the tools and skills required.

• To reduce the possibility of fire or explosion, be careful when

working around gasoline. Use only a nonflammable solvent, not

gasoline, to clean parts. Keep cigarettes, sparks and flames away

from all fuel related parts.

Remember that an authorized Honda servicing dealer knows your

engine best and is fully equipped to maintain and repair it.

To ensure the best quality and reliability, use only new genuine Honda

parts or their equivalents for repair and replacement.

MAINTENANCE SCHEDULE

(1) Service more frequently when used in dusty areas.

(2) Change engine oil every 25 hours when used under heavy load

or in high ambient temperatures.

(3) These items should be serviced by an authorized Honda

servicing dealer, unless you have the proper tools and are

mechanically proficient. Refer to the Honda shop manual for

service procedures.

(4) For commercial use, log hours of operation to determine proper

maintenance intervals.

Failure to follow this maintenance schedule could result in non-

warrantable failures.

REFUELING

Use unleaded gasoline with a pump octane rating of 86 or higher.

This engine is certified to operate on regular unleaded gasoline.

If the fuel level is low, refuel in a well-ventilated area with the engine

stopped. If the engine has been running, allow it to cool first. Never

refuel the engine inside a building where gasoline fumes can reach

flames or sparks.

You may use regular unleaded gasoline containing no more than 10%

Ethanol (E10) or 5% Methanol by volume. In addition, Methanol must

contain cosolvents and corrosion inhibitors. Use of fuels with content

of Ethanol or Methanol greater than shown above may cause starting

and/or performance problems. It may also damage metal, rubber, and

plastic parts of the fuel system. Engine damage or performance

problems that result from using a fuel with percentages of Ethanol or

Methanol greater than shown above are not covered by warranty.

NOTICE

Fuel can damage paint and some types of plastic. Be careful not to

spill fuel when filling your fuel tank. Damage caused by spilled fuel is

not covered under the Distributor’s Limited Warranty (see page 11).

Never use stale or contaminated gasoline or oil/gasoline mixture.

Avoid getting dirt or water in the fuel tank.

Move at least 3 meters (10 feet) away from the fueling source and site

before starting the engine.

1. Remove the fuel tank

cap.

2. Add fuel to the bottom of

the fuel level limit in the

neck of the fuel tank. Do

not overfill. Wipe up

spilled fuel before

starting the engine.

3. After refueling, tighten

the fuel tank cap.

a. Non-tether type:

Tighten the cap securely.

b. Tether type:

Tighten the cap until it

clicks.

ENGINE OIL

Recommended Oil

Use 4-stroke motor oil that meets

or exceeds the requirements for

API service classification SJ, or

later. Always check the API

service label on the oil container

to be sure it includes the letters

SJ, or later.

SAE 10W-30 is recommended for general use. Other viscosities

shown in the chart may be used when the average temperature in

your area is within the indicated range.

Oil Level Check

1. Check the oil with the engine stopped and level.

2. Remove the oil filler cap/dipstick and wipe it clean.

3. Insert the oil filler cap/dipstick into the oil filler neck as shown, but

do not screw it in, then remove it to check the oil level.

4. If the oil level is near or below the lower limit mark on the dipstick,

fill with the recommended oil to the upper limit mark (bottom edge

of the oil fill hole). Do not overfill.

ITEM

Perform at every

indicated month or

operating hour interval,

whichever comes first.

REGULAR SERVICE PERIOD (4)

Page

Before

Each

U s e

First

M o n t h

5 Hrs

Every 3

M o n t h s

25 Hrs

Every 6

Months

50 Hrs

Every

Year

100 Hrs

Every

T w o

Years

or 250

Engine oil

Check O5

Change OO (2) 6

Air filter

Check O

6Clean O (1)

Replace O

Spark plug

Check-adjust O

Replace O

Spark arrester Clean O7

Idle speed Check-adjust O(3)

Shop

manual

Fuel tank and filter Clean O(3)

Shop

manual

Fuel tube Check

Every 2 years

(Replace if necessary) (3)

Shop

manual

Valve clearance Check-adjust O(3)

Shop

manual

Combustion chamber Clean After every 250 hours (3)

Shop

manual

 WARNING

Gasoline is highly flammable and explosive, and you can

be burned or seriously injured when refueling.

• Stop engine and keep heat, sparks, and flame away.

• Refuel only outdoors.

• Wipe up spills immediately.

MAXIMUM FUEL LEVEL

FUEL TANK

CAP

TETHER

AMBIENT TEMPERATURE

GC190-160 om-english.fm Page 5 Thursday, August 24, 2006 3:29 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GC190 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GC190

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info