Bedienungsanleitung Honda Honda Engines GC190 (Seite 8 von 44) (Englisch)

13057

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

ENGLISH

DRAINING THE FUEL TANK AND CARBURETOR

1. Use a siphon pump (commercially available) and siphon the fuel

out of the fuel tank into an approved gasoline container.

2. Place an approved gasoline container below the carburetor, and

use a funnel to avoid spilling fuel.

3. Loosen the carburetor drain screw. and drain the carburetor into an

approved gasoline container. After draining is completed, tighten

the carburetor drain screw.

Engine Oil

1. Change the engine oil

(see page 6).

2. Remove the spark plug

(see page 6).

3. Pour a tablespoon

(5 - 10 cc) of clean engine

oil into the cylinder.

4. Pull the recoil starter several

times to distribute the oil.

5. Reinstall the spark plug.

Storage Precautions

If your engine will be stored with gasoline in the fuel tank and

carburetor, it is important to reduce the hazard of gasoline vapor

ignition. Select a well-ventilated storage area away from any

appliance that operates with a flame, such as a furnace, water heater,

or clothes dryer. Also avoid any area with a spark-producing electric

motor, or where power tools are operated.

If possible, avoid storage areas with high humidity, because that

promotes rust and corrosion.

Keep the engine level in storage. Tilting can cause fuel or oil leakage.

With the engine and exhaust system cool, cover the engine to keep

out dust. A hot engine and exhaust system can ignite or melt some

materials. Do not use sheet plastic as a dust cover. A nonporous

cover will trap moisture around the engine, promoting rust and

corrosion.

Removal From Storage

Check your engine as described in the BEFORE OPERATION

CHECKS section of this manual (see page 2).

If the fuel was drained during storage preparation, fill the tank with

fresh gasoline. If you keep a container of gasoline for refueling, be

sure it contains only fresh gasoline. Gasoline oxidizes and

deteriorates over time, causing hard starting.

If the cylinder was coated with oil during storage preparation, the

engine will smoke briefly at startup. This is normal.

TRANSPORTING

Keep the engine level when transporting to reduce the possibility of

fuel leakage.

TAKING CARE OF UNEXPECTED PROBLEMS

 WARNING

Gasoline is highly flammable and explosive, and you can

be burned or seriously injured when handling fuel.

• Stop engine and keep heat, sparks, and flame away.

• Refuel only outdoors.

• Wipe up spills immediately.

SIPHON PUMP

(COMMERCIALLY

AVAILABLE)

FLOAT BOWL

DRAIN SCREW

ENGINE WILL NOT

START

Possible Cause Correction

1. Check control positions Choke open. Pull the choke to the

CLOSED position unless

the engine is warm.

Ignition switch OFF. • Move the throttle lever to

the SLOW or FAST

position (p.3).

• Move the ignition switch

lever to the ON position

(p. 3).

• Move the engine stop

switch to the ON position

(p. 4).

2. Check engine oil level. Engine oil level low (Oil Alert

models).

Fill with the recommended

oil to the proper level (p. 5).

3. Check fuel. Out of fuel. Refuel.

Bad fuel; engine stored

without treating or draining

gasoline, of refueled with bad

gasoline.

Drain the fuel tank and

carburetor (p. 8). Refuel

with fresh gasoline.

4. Remove and inspect

spark plug.

Spark plug faulty, fouled, or

improperly gapped.

Replace the spark plug

(p. 6).

Spark plug wet with fuel

(flooded engine).

Dry and reinstall spark

plug. Start engine with

throttle lever in FAST

position (choke in OPEN

position).

5. Take engine to an

authorized Honda

servicing dealer, or refer

to shop manual.

Fuel filter clogged, carburetor

malfunction, ignition

malfunction, valves stuck,

etc.

Replace or repair faulty

components as necessary.

ENGINE LACKS

POWER

Possible Cause Correction

1. Check air filter Filter clogged. Clean or replace the filter

(p. 6).

2. Check fuel. Bad fuel; engine stored

without treating or draining

gasoline, of refueled with bad

gasoline.

Drain the fuel tank and

carburetor (p. 8). Refuel

with fresh gasoline.

3. Take engine to an

authorized Honda

servicing dealer, or refer

to shop manual.

Fuel filter clogged, carburetor

malfunction, ignition

malfunction, valves stuck,

etc.

Replace or repair faulty

components as necessary.

POM53483-F.book Page 8 Thursday, August 24, 2006 1:34 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GC190 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GC190

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info