13077
9
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
9
ENGLISH
Short Term Storage (30 - 90 days)
If your equipment will not be used between 30 and 90 days, we
recommend the following to prevent fuel-related problems:
1. Add fuel stabilizer following the manufacturer’s instructions.
When adding a fuel stabilizer, fill the fuel tank with fresh gasoline. If
only partially filled, air in the tank will promote fuel deterioration
during storage.
Note:
All stabilizers have a shelf life and their performance will
deteriorate over time.
Fuel stabilizers will not reconstitute stale fuel.
2. After adding a fuel stabilizer, run the engine outdoors for
10 minutes to be sure that treated gasoline has replaced the
untreated gasoline in the carburetor.
Long Term or Seasonal Storage (greater than 90 days)
1. Use a siphon pump (commercially available) and siphon the fuel
out of the fuel tank into an approved gasoline container. (see
Figure 13, page 3)
2. Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
3. Loosen the carburetor drain screw [1] and drain the carburetor into
an approved gasoline container. After draining is completed,
tighten the carburetor drain screw.
ENGINE OIL
1. Change the engine oil (see page 7).
2. Remove the spark plug (see page 8).
3. Pour 1 - 2 teaspoons (5 ~ 10 cc) of clean engine oil into the
cylinder.
4. Pull the recoil starter several times to distribute the oil.
5. Reinstall the spark plug.
STORAGE PRECAUTIONS
If your engine will be stored with gasoline in the fuel tank, it is
important to reduce the hazard of gasoline vapor ignition. Select a
well-ventilated storage area away from any appliance that operates
with a flame, such as a furnace, water heater, or clothes dryer. Also
avoid any area with a spark-producing electric motor, or where power
tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Keep the engine level in storage. Tilting can cause fuel or oil leakage.
With the engine and exhaust system cool, cover the engine to keep
out dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous
cover will trap moisture around the engine, promoting rust and
corrosion.
Removal From Storage
Check your engine as described in the BEFORE OPERATION
CHECKS section of this manual (see page 4).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
TRANSPORTING
Keep the engine level when transporting to reduce the possibility of
fuel leakage. Turn the fuel valve to the OFF position.
Review the instructions provided with the equipment powered by this
engine for any procedures that should be followed for transporting.
TAKING CARE OF UNEXPECTED PROBLEMS
Engine will not start
Engine lacks power
WARNING
Gasoline is highly flammable and explosive, and you can
be burned or seriously injured when handling fuel.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
POSSIBLE CAUSE CORRECTION
Choke is OFF. Unless the engine is warm, move
the choke lever to the CHOKE
position.
Ignition switch or engine stop
switch is OFF.
Move the throttle lever to the
SLOW or FAST position
Move the ignition switch lever to
the ON position
Move the engine stop switch to
the ON position
Engine oil level is low (oil alert
models)
Fill with the recommended oil to
the proper level (page 7).
Out of fuel. Refuel
Bad fuel; engine stored
without treating gasoline, or
refueled with bad gasoline.
Drain the fuel tank and carburetor.
Refuel with fresh gasoline.
Spark plug faulty, fouled, or
improperly gapped.
Adjust or replace the spark plug
(page 8).
Spark plug wet with fuel
(flooded engine).
Dry and reinstall the spark plug.
Start the engine with the choke in
the OFF position and the throttle
lever in the FAST position.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck, etc.
Take the engine to an authorized
Honda servicing dealer or refer to
the shop manual to replace or
repair faulty components as
necessary.
POSSIBLE CAUSE CORRECTION
Air filter clogged. Clean or replace the air filter
(page 7).
Bad fuel; engine stored
without treating the gasoline,
of refueled with bad gasoline.
Drain the fuel tank and carburetor.
Refuel with fresh gasoline.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck, etc.
Take the engine to an authorized
Honda servicing dealer or refer to
the shop manual to replace or
repair faulty components as
necessary.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honda Honda Engines GS190 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Honda Honda Engines GS190

Honda Honda Engines GS190 Bedienungsanleitung - Deutsch - 32 seiten

Honda Honda Engines GS190 Bedienungsanleitung - Englisch - 16 seiten

Honda Honda Engines GS190 Bedienungsanleitung - Holländisch, Italienisch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info