Bedienungsanleitung Honda HRX537 HMEA (Seite 12 von 22) (Englisch)

580909

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

ENGLISH

Dry Grass

If the ground is too dry, mowing will stir up a lot of dust. Besides being

unpleasant to work in, too much dust will clog the carburetor air filter.

If dust is a problem, water your lawn the day before mowing. Mow

when the grass is dry to your touch, but the soil is still moist.

Wet Grass

Wet grass is slippery and can make you lose your footing. Also, wet

grass clippings will clog the mower deck and collect in clumps on the

lawn. Always wait for wet grass to dry before mowing.

Fallen Leaves

Your mower can be used to pick up fallen leaves for disposal. If using

the mower to bag large amounts of fallen leaves, and not for mowing,

set the cutting height adjustment levers so the front of the mower

deck is one or two settings higher than the rear. To start, position the

Clip Director knob in the #9 position (not quite full mulching). This

setting will allow the leaves to be recirculated and recut until the

particles are small enough to pass though the sliding door opening

and into the grass bag. Depending on the size, type, and water

content of the leaves, it may be necessary to open the sliding door to

allow for best bagging results. Using the sliding door correctly will

allow better grass bag filling, resulting in less grass bag emptying. Be

sure there are no obstacles, including rocks, hidden under the leaves.

If you want to mulch fallen leaves into your lawn, don't let the leaf

cover get too deep before you begin. For best results, start mulching

while grass still shows through the leaf cover. Position the Clip

Director knob in the MULCH position. In places where fallen leaves

completely cover the grass, remove the leaves by raking, or use the

grass bag so your mower can pick them up for disposal.

Clogged Mower Deck

Before clearing a clogged mower deck, stop the engine and turn the

fuel valve to the OFF position. With the spark plug cap disconnected,

tilt the mower so the air cleaner side is up.

Clear a clogged deck with a stick, not your hands.

Mowing Patterns

Your Honda mower will work most efficiently if you use the following

mowing patterns as much as possible. Mower deck and equipment

design, and the direction in which the blades rotate, cause these

mowing patterns to give the best results.

Mulching

Use a counterclockwise mowing

pattern when the Clip Director

knob is in the full MULCH

position. If the lawn has an

irregular shape, or many

obstacles, divide it into sections

where you can use

counterclockwise mowing

patterns.

Bagging

Use a clockwise mowing pattern.

This will give the best Clip

Director and bagging

performance, leaving the least

amount of clippings on the lawn.

Rear Discharge Mowing

Remove the grass bag and close

the discharge guard. Adjust the

Clip Director knob to the desired

setting and begin mowing in a

clockwise mowing pattern. If the

lawn has an irregular shape, or

many obstacles, divide it into

sections.

TRANSPORTING/STORAGE

TRANSPORTING

Before Loading

If the engine has been running, allow it to cool for at least 15 minutes

before loading the mower on the transport vehicle. A hot engine and

exhaust system can burn you and can ignite some materials.

Turn the fuel valve to the OFF position. This will prevent carburetor

flooding and reduce the possibility of fuel leakage.

Handlebar Folding

1. Remove the grass bag, if

so equipped. You can

place it on top of the

engine, with the bag

opening to the front.

2. Loosen the lower

handlebar locking knobs

[1].

3. Spread the lower ends of

the handlebar struts [2]

to release the locating

pins. Fold handlebar

over mower.

When folding the handlebar, be careful to avoid kinking or pinching

the control cables.

Loading and Unloading

Position the mower so all four wheels are on the bed of the transport

vehicle. Tie the mower down with rope or straps, and block the

wheels. Keep the tie-down rope or straps away from the controls,

adjustment levers, cables, and the carburetor.

MULCHING PATTERN

BAGGING & REAR-DISCHARGE

PATTERN

OFF

[1]

[2]

HXE.book Page 12 Monday, August 6, 2007 10:44 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda HRX537 HMEA Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info